Wheel nut short. Suitable for Renault R4 + R6. Thread: M10 x 1.25, wrench: 17mm. Or. No
7700636440, 0555486900, 7700610483. Made by Franzose / CiPeRe
for Renault R5-R6
1433 Articles | Page 23 of 29
Wheel nut, suitably for R16TX, R12, R15, R17, R18, R20, R30 etc. Thread: M12 x 1,25. Overall
height: 32,5mm. Tapered. Wrench: 19,0mm. Or. No. 7700618233
Wheel nut, suitable for Renault R16TX, R12, R15, R17, R18, R20, R30 etc.. Thread: M12 x 1.25
Height: 38.5mm. Tapered collar. Width across flats: 19.0mm. Or. No. 7700532727
The brake-down aid for on the road. SONAX TyreFix restores driveability to flat tyres, without tyre
change. Seals small holes in the tyre and pumps it up. Practical, fast and safe. 400ml
Renault emblem, universal. Dimension: 62 x 50mm. Material: Synthetic. Fastening: 2x split pins with
5mm diameter (the pins have a bar, with bar the diameter is 6mm).
Rosette 13/5mm with screw. Contents: 12 pieces + 12x screw 4mm/16mm. This rosette consists only of
a punched-out sheet metal which has been nickel-plated. They are not as sturdy and pretty as our numbers 21143, 21144, 21145, but these rosettes are more like the original rosettes used in early Citroen 2CV, R4, Dauphine etc. Higher-quality vehicles were more likely to have our shiny alternatives (e.g. Citroen DS).
Rosette from rubber synthetic, frame of the trunk lock, suitable for Renault R16, R5, R6, R18. 1
art drinking hook. Inside diameter: about 20mm. Outside diameter: about 32mm. Or.Nr. 556130100
Rosette from rubber synthetic, frame of the door lock, suitable for Renault R16, R6. 4 synthetic
hooks. Inside diameter: about 20mm. Outside diameter: about 32,5mm. Or.Nr. 7700565962
Rosette from rubber synthetic, frame of the door lock, suitable for Renault R4. Inside diameter
about 22mm. Outside diameter: about 33,0mm. Or. No. 7700537758
Rust eraser pen. Ideal for removing even the smallest rust spots. Indispensable! And, of course
the cleaned rust spot must then be preserved with paint immediately.
Back-up light reproduction (Hella), the housing is made of plastic. Width 120mm, height of 70mm
The headlamp is for a later mounting underneath the bumper! It cannot be used as substitute for the original backup lights from R4! Lampholder for the bulb: Ba15s. Maximum 21Watt. (Our number 14035 + 14045).
Return stop (valve) for fuel or windscreen washer fluid. Connection: 6 mm. This valve is a real
improvement for classic vehicles that use a hand pump without a ball valve to deliver water. This ensures that windscreen washer fluid is always available at the spray nozzles. Please note the direction of flow during installation! It also prevents petrol from flowing back in the fuel line (useful for longer periods of inactivity). Please install this valve close to the petrol pump (between the petrol pump and the tank).
Reflector square, framed in metal. With fixing straps, dimensions approx. 60x45mm. These reflectors
were used in many French cars!
Switch - push button, square, with chrome frame. Universally suitable. Please note: this is a push
button and not a toggle switch. The push button is useful for electric windscreen washers, horns or headlight flashers, for example. Dimensions: 36x18mm (French standard size). Suitable for Peugeot, Citroen, Renault.
Square switch with chrome frame. The switch also has an indicator light (bulb base Ba9s). Universal
switch for e.g. heater blowers, additional consumers.... Dimensions: 36x18mm (French standard size). Suitable for Peugeot, Citroen, Renault.
Switch for the reversing lamp. Suitable for Renault R4, R5, R6, R16. Thread: M16 x of 1,0. 2
electric plug contacts.
Discs (windscreen) Pull-in tool (cord with handle). This is used to pull the rubber lip of the seal
over the sheet metal fold. Very helpful!
Windscreens (windscreen) piping assembly tool - bracket inserts. For small piping. There are 5
brackets in different widths so that narrow and wide piping can be fitted (e.g. for the 2CV, R4....). Suitable for tool with item number 20134.
Windscreen Installation Tool Set. Windshield sealing trim assembly tool. With this tools will the
rubber lip (seal) inclination (spread) and it can fit the sealing trim at the same time. Attention: The tool is for very wide piping. For chrome piping e.g. Citroen 2CV, Renault R4 etc. small brackets must be fitted. See our item number 20137.
Permanently elastic window sealant. Original Teroson! 75ml tube. Application : Ideal for sealing
rubber-mounted front, rear and side windows. Very stable, water resistant, remains elastic. Good adhesion even on damp windscreens.
Vehicle Window sealant permanent elastic. Original Teroson! Cartouche 310ml. Application: Ideally
to sealing rubber-mounted front. - Tail and side windows. Very stably, water-resistant, remains elastic. Good adhesion also on wet disk.
Windscreen washer reservoir - plastic bag with integrated electric water pump. 12 volts. The
reservoir is supplied with mounting and accessories and can be installed in any vehicle, e.g. Citroen Mehari, Renault R4 first versions, etc. This type of windscreen washer reservoir has also been installed in many Italian vehicles (Alfa Romeo Spider...).
Washer reservoir electrical with built-in set for 2CV and other classical cars. Complete with
h push-button, cable, cross bars etc. very practical and small. Width 19,5cm, height of 16,5cm, depth 5,5cm
Washer reservoir with integrated, electrical water pump. 12 V. Capacity: 1.2 L. width: 122mm
overall height totally: 185mm. Building depth altogether: 100mm. The reservoir is supplied with fixture. The fixture is from the rear at the reservoir.
Windscreen washer reservoir with integrated electric water pump. 12 volt. Suitable for Renault R4
R5, R6, R7, R12. Corresponds to original number: 7700628056
Wiper nozzle synthetic grey. Universal fitting. 4mm hose connection. The wiper nozzle is locked
with a nut from rear. 1 water jet. Low body height. Mounting diameter: 8,0mm.
Windscreen washer nozzle black. Universal fitting. 4mm hose connection. The washer nozzle is
screwed with a nut from behind. 2x water jet. Flat design.. Mounting diameter: 8,0mm.
Washer pump electrical. 12 V. Very stable version with galvanized metal fixture. 2x flat plug
connection from above! Made in the European Union. The picture indicates the correct mounting position. The pump section is down, the electric motor above!
Foot-operated pump set for windschield wiper fluid. Consisting of foot pump, 2 return flow
stoppers, 1x T-valve, 3 meters hose. Assembly: Starting from the foot pump with the T-valve, 1x to the reservoir (place the valve in such a way that the water from the reservoir can pass through) and 1x to the windshield washer nozzle (valve lets the water pass in the direction of the nozzle). The flow directions are marked with an arrow on the valve. Assembly instruction online in the shop.
PDF FILE Windscreen washing water hand pump. Reproduction, completely with sheet metal holder for a later
mounting! Suitable for Citroen 2CV. In addition, the pump can be universal installed.
1433 Articles | Page 23 of 29
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
