for Sonstige-Citroen DS
3321 Articles | Page 62 of 67
Identification plate green, for Citroen. 78x40mm. 2 bores. (Metal). The green identification plates
were often used for gearbox identification!
Identification plate orange, for Citroen. 78x40mm. 2 bores. (Metal). The red identification plates
were often used for engine numbers!
Identification plate S.A.A Citroen. These identification plates are installed in 2CV, DS, 11CV, HY
Measurements of 43x70mm. Unfortunately a bad reproduction.
Identification plate, original-faithful reproduction. Suitable for Citroen 2CV, DS, HY, 11CV
Measurements: 43 x 78mm.
Transmission rod (complete) of the steering movement to the auxiliary headlights. Consisting of
DX541-143A + DX541-161 + DX541-144. Suitable for Citroen DS, starting from year of construction 1967.
Conversion traverse for Citroen BREAK, to use a normal rear seat bench from Citroen DS sedan
Reproduction, from a original Citroen part from the sixties!
Transfer pump metal version, inclusive 2 hoses for drawing in and running off, 500ccm. Applicable
e for: Diesel, fuel oil, coolant, brake fluid.
Steering arm for linking the tie rods. Suitable for Citroen DS. New parts. Reproduction inclusive
bearing and seal. Note: Original is 46mm diameter Installed, we supplies the set with 47mm. The bearing seat must therefore be extended! Otherwise a repair kit would be useless!
Reversing lever steering unit: Plate for the bearing block. Suitable for Citroen DS, to year of
construction 1965. Dimension: 35 x 43 x 10mm. Or. No. 620061
Reversing lever steering unit: Ball for the bearing of the lever. Suitable for Citroen DS, to year
of construction 1965. Diameter: 6,7mm. Or. No. Or. No. 4102S
Steering lever arm: sealing at top + bottom, for the steering lever arm. Dimension: 32 x 47 x 7mm
The sealing ring is suitable for the repair kit steering lever (item 34629).
Seal down + above, for the steering unit reversing lever bearing. Dimension: 32 x 46 x 7mm. Or. No
ZC9612641U + ZC9621608U. Made in Germany.
Seal down, for the steering reversing lever. Suitable for Citroen DS 19, of year of construction
1960 to 1965. Dimension: 28 x 52,5mm. Or. No. DS443-78
PDF FILE 
Vacuum hose (1030mm), before the throttle valve (connection from the rear) and 3 path connector for
auxiliary air slide valve. Suitable for Citroen DS IE. Inside diameter: 11,0mm. Length: 1030mm. Or. No. 2D5411135K
Vacuum hose, behind the throttle valve (Connection laterally) and 3 way connector for auxiliary air
slide valve. Suitable for Citroen DS IE. Inside diameter: 11,0mm. Length: 608mm. Or. No. DX144-218A
Vacuum hose for the full load switch. Suitable for Citroen DS IE (injection engine). Outside
diameter: 10mm. Inside diameter short side: about 4mm. Inside diameter long side: about 5,5mm. Or. No. DX144243A
Vacuum hose, between throttle valve case and pressure sensor. Suitable for Citroen DS IE. Inside
diameter: 7,0mm. Or. No. DX144-226A
Lower cover sheet on the left, for the hydraulic lines (horizontal mounting). For the wheel housing
in front on the left. Suitable Citroen DS. Or. No. DX434-106.
Lower cover sheet on the left, for the hydraulic lines (horizontal mounting). For the wheel housing
in front on the left. Suitable Citroen DS. Or. No. DX434-106. Orignal Citroen, no reproduction. Inclusive Seal and rubber plug.
Lower cover sheet on the right, for the hydraulic lines (horizontal mounting). For the wheel
housing in front on the right. Suitable Citroen DS. Or. No. DX434-107.
Lower cover sheet metal on the right, for the hydraulic lines (horizontal mounting). For the wheel
housing in front on the left. Suitable Citroen DS. Or. No. DX434-107. Orignal Citroen, no reproduction. Inclusive seal and rubber plug.
3321 Articles | Page 62 of 67
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
