for Sonstige-Citroen R5-R6
1451 Articles | Page 17 of 30
R4/R5, repair kit for the rack guide (right) in the steering gear. Outer diameter 30mm. Suitable
for Renault R4, R5, R6. Fits Renault R4 FASA vehicles! Or. No. 7700580524
R4/R5, repair kit for the rack guide (right) in the steering gear. Outer diameter 32mm. Suitable
for Renault R4, R5, R6. Not suitable for FASA R4! Or. No. 7701455251
R4/R5, Bracket for gear lever in the cross member at the front above the engine. Fits Renault R5
Also fits on Renault R4 (but is relatively unknown). As original, but with additional dust boot (better sealing). The middle plastic ring is made of self-lubricating plastic. Or. No. 7700560542 + 7700560543 + 7700560544
R4/R5, gear shift lever repair kit. Suitable for Renault R4 + R5. For the Renault R4, the two
plastic bushings are not needed! Or. No. 7700532414 + 7700520531
R4/R5, thrust strut bearing. Suitable for Renault R4. Note: Only suitable for thrust strut with
fork mounting. (Support of lower wishbones). Per piece. Or. No. 7700500113
R4/R5, bonded-rubber bushing (2 fittings) for the bearing of the rear axle rocker. Suitable for
Renault R4, R5, R6, Alpine A110. Inside diameter: 34mm. Outside diameter: 50mm. Length inside: 45mm. Length outside: 39,5mm.
R4/R5, tie rod end. Suitable for Renault R4, starting from year of construction 1979. Renault R5
R6, R18, R20. The tie rod fits on the left + on the right. Thread for the tie rod: M14 x 1,5. Or. No. 7701460955 Made in Italy
R4/R5, anti roll bar suspension point outside. Suitable for Renault R4 + R5. Diameter metal sleeve
10,1mm. Metal sleeve lengthens: 32mm. Or. No. 7702003408
R4/R5, anti roll bar suspension point outside. Suitable for Renault R4 + R5. Diameter metal sleeve
10,1mm. Metal sleeve lengthens: 51mm. Or. No. 7702107984
R4/R5, anti roll bar suspension point outside. Suitable for Renault R4 + R5. Diameter metal sleeve
12,1mm. Metal sleeve lengthens: 32mm.
R4/R5, anti roll bar suspension point outside. Suitable for Renault R4 + R5. Diameter metal sleeve
12mm. Metal sleeve lengthens: 51mm. Or. No. 7702107985
R4/R5, Anti roll bar repair set, for 10mm anti roll bar. Suitable for Renault R4 + R5. Contents: 2x
clip, 2x rubber bush for clip, 2x hanging up rubber outside. Metal sleeve length = 32 mm. Note: The rubber bush for fixture anti roll bar at the body has always about 15-16mm diameter
Anti roll bar repair set, for 12mm anti roll bar. Suitable for Renault R4 + R5. includes: 2x clip
2x rubber bush for clip, 2x suspension rubber outside (Metal sleeve = 32mm). Note: The rubber bush for fixture anti roll bar at the body has always about 15-16mm diameter
Camshaft drive chain, 64 chain links (simplex chain). Suitable for Renault R4, R5, R6, R8, R12
TWINGO. Engines: C, C1C, C1E, 680, 688, 810, 813, 839, 899, 810-02, C3G700.
R4/R5, front shock absorbers (2 pieces, reproduction). Suitable for Renault R4, built between
09/1968 and 1992. R4 F4 + R4 F6 from 1968 to 1992. Renault R5, built between 1972 and 1985. Renault R6.
R4/R5, shock absorber front (1 piece). Suitable for Renault R4, of year of construction 09/1968 to
1992. R4 F4 + R4 F6 from 1968 to 1992. Renault R5, of year of construction 1972 to 1985. Renault R6. Manufacturer "Record France"
R4/R5, fuel sender (last version), with fuel return. For bayonet mount. Suitable for Renault R4
(S128, R112C, R1128, R210B, R2370, R2398), Renault R5. For vehicles that have a fuel pump with 3 hose connections. Attention: Vehicles were produced in the same period which may or may not have a fuel return. Please check on your vehicle. Or. No. 7701349130
R4/R5, ball and socket joint lower on the left. Suitable for Renault R4 + R5. Installed from year
of construction 1979 to 1992. Pin amount to area for screwing: 62mm. Thread height: 19mm. Thread measurement: M12 x 1,25.
R4/R5, ball and socket joint lower on the right. Suitable for Renault R4 + R5. Installed from year
of construction 1979 to 1992. Pin amount to area for screwing: 62mm. Thread height: 19mm. Thread measurement: M12 x 1,25. Or. No. 7701463687
R4/R5, ball and socket joint: Screw M6X1, length 20mm. Tensile strength 10.9 (as original) for the
bolting of the suspension and guide joints on the front axle. Per piece.
R4/R5, Gear wheel for the crankshaft, 19 teeth. Suitable for Renault R4 + R5. Engines: 782cc +
845cc. Installed from 10/1962 to 07/1989. Outside diameter: 61mm. Inside diameter: 25mm. Amount: 26mm. Or. No. 7701348994. Original supplier.
Gear camshaft. 34 teeth. Suitable for Renault R4, R5. Note: The gear has centrically in the
mounting a pin! Engines 1108cc + 956cc. Installed by the R4 from 06/1978 to 06/1990. By R5 from 01/1972 to 12/1985. Or.Nr. 7700655335
R4/R5, cylinder head gasket set. Engine: 813-02, C1C, 688 (852ccm, 956ccm, 1108ccm). Bore: 61,4 +
65.0 + 70,0mm. Suitable for Renault R4. Renault R5 TL-GTL (1972 - 1985). R6, Estafette
R4/R5/Estafette/Caravelle, thrust washer for the crankshaft, from 1975 onwards. Engines Renault
688.02/10/11,688, C1E (1108ccm). Standard dimension
R4/R5/rear engine, oil pan seal gearbox side, for the following engines: 688 711, 688 712
CIC700/6/8/54, CIE700, CIE 714/15/28/19. Engine capacity: 956cc, 1108cc, 1237cc, 1397cc. Suitable for Renault R4, R8, R10, Super5, Clio, R11. Or. No. 0852937800
R4/R5/rear engine, oil pan seal at the front side, for the following engines: 688,711, 688,712
CIC700/6/8/54, CIE700, CIE 714/15/28/19. Engine capacity: 956cc, 1108cc, 1237cc, 1397cc. Suitable for Renault R4, R8, R10, Super5, Clio, R11. Or. No. 7700860636
Gear camshaft, 34 teeth. Suitable for Renault R4, R5, R10. 845ccm, 1108ccm, 1289ccm. Note: The
mounting centrically has a projection!
R4/R5/R12, gear rim fly wheel. 117 teeth. Suitable for Renault R4, R5, R12. Inside diameter
22,2cm. Outside diameter: 24,7cm. Thickness: 0,8cm.
R4/R5/R16, brake power controller - connecting bolt (regulating rod) for brake load-dependent
actuation (on the rear axle). The bolt is threaded and the tractive force is adjusted via 2 nuts. This bolt is suitable for the brake power controller with 3 and 4 lines! Suitable for Renault R4, R5 TS + TL, R16. Or. No. 7700506146 + 6001003791
R4/R5/R16, brake power controller suspension spring. This spring is suitable for the brake power
controller with 3 and 4 lines! The brake power controller is suspended from this spring! Suitable for Renault R4, R5 TS + TL, R16. Or. No. 7700514841
R4/R5/R16, brake power regulator bracket. This bracket is suitable for the brake power regulator
with 3 and 4 lines! Suitable for Renault R4, R5 TS + TL, R16. Or. No. 7700629722 + 7700629723
R4/R5/R16, brake power controller tension spring (for brake load-dependent actuation). This spring
is suitable for the brake power controller with 3 and 4 lines! Suitable for Renault R4, R5 TS + TL, R16. Or. No. 7700514080
R4/R5/R16, brake power controller, 3 brake line connectors (2x E-flange + 1x F-flange). Suitable
for Renault R4, starting from year of construction 1968. Renault R16, all model`s. Renault R5 TS + TL, R6
R4/R5/R16, electric motor for the radiator fan. Suitable for R4 (1108cc). Renault R5, R6, R9, R11
R14, R16, R18, R19, Espace. Or. No. 7700828623
R4/R5/R16, Kühlerlüfter incl. Lüfterflügel. Passend für Renault R4 (1108ccm), R5, R6, R9, R11
R14, R16, R18, R19, Espace.
R4/R5/R16, locking ring for radiator fan (fixing fan blade to fan motor). For 8mm shaft. Suitable
for Renault R4 (1108ccm), R5, R6, R9, R11, R14, R16, R18, R19, Espace.
R4/R5/R6, brake hose front. Suitable for Renault R4, starting from year of construction 1976 (disc
brake). Renault R5, R6. Length: 433mm. Thread: 1x male thread 3/8 x 24UNF. 1x female thread 3/8 x 24UNF. Or. No. 7700545267. Made in Europe.
R4/R5/R6, master brake cylinder, single circuit brake system. Brake system: Bendix. Suitable for
Renault R4 (R1123), to year of construction 1976. Renault R4 (R1129) from 1976 to 1978. Renault R4 F4 (R2391, R2392), of year of construction 1971 to 10/1976. R4 F6 (R2370, R2340), of year of construction 4/1975 to 10/1976. Renault R5 (0,8) from 10/1972 to 12/1984. R6 from 10/1969 to 4/1980. Piston diameter: 19,05mm. Brake line connector: 3x 3/8x24UNF. Made in Europe.
R4/R5/R6, master brake cylinder, suitable for Renault R4 to Ident No. 1109666 (vehicles with front
drum brake). Renault R5 0,8L, of year of construction 10/1972 to 08/1984. Renault R6, of year of construction 10/1969 to 04/1980. Piston diameter: 22mm. Brake line connector: 3x 3/8x24 UNF + 1x at the front side 7/16x20 UNF. The actuating piston has a bore with 11mm diameter and about 40mm deep.
R4/R5/R6, master brake cylinder, dual circuit brake system. Brake system: Bendix (drum brake
front). Suitable for Renault R4, R5, R6. Piston diameter: 20,64mm. Brake line connector: 3x M10x1 + 1x M12x1. Or. No. 7700617298 + 7701348468. Made in Europe.
R4/R5/R6, master brake cylinder. Piston diameter: 20,64mm. Suitable for Renault R4, R5, R6. Brake
line connector: 3x M10 + 1x M12. Made in Europe.
R4/R5/R6, engine suspension in front on the left. Suitable for Renault R4 (R1128, R2370, R2430), of
year of construction 1976 to 1982. R4 (R1128, R112C, E210B, 2370, R239B, RS128), starting from year of construction 1983. R5. R6, starting from year of construction 1970.
1451 Articles | Page 17 of 30
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
