for Citroën 11CV-15CV
1262 Articles | Page 25 of 26
Hazard warning lights switch 6 Volt! Manufacturer Bosch! The hazard flasher system uses the
existing flasher relay and is relatively easy to install. Attention: a suitable bulb must be ordered separately. Our article number 14282.
PDF FILE 
Hazard warning signal switch, universal, 12volt, Manufacturer HELLA The switcher uses the actual
indicator-relais. easy to fit.
Hazard warning light switch, manufacturer Hella. Complete with mounting bracket for retrofitting
The hazard warning light switch is operated via the original flasher relay. Suitable light bulb: 50096 for 12 V. 14271 for 6 V.
Water pump completely in the exchange. Suitable for Citroen 11CV, starting from year of
construction 09/1950. Plus 250 Euro Old part deposit! Or. No. 456649
Water pump completely in the exchange. Suitable for Citroen 11CV, to year of construction 09/1950
The water pump was completely revised and optimized. Like that the new pump impellers with 8 shovels are mounted instead of 6 shovels. Additionally the axle with 2 shaft seals is sealed. The pump must be only easily lubricated. Too much lubricating grease destroys the shaft seals! Plus 250 Euro Old part deposit! Or. No. 451643
Water pump plate, between engine block + water pump. Amended for mounting a water temperature
sensor (M10, 1/8" NPTF). Suitable for Citroen 11CV Perfo (to year of construction 1950). In the exchange. Plus 75 Euro Old part deposit.
Water pumps seals (2 fittings). Suitable for Citroen 15CV, Installed starting from year of
construction 09/1947. Or. No. 452673 + 456723
Water hose screen wiping water, PVC clear. Inside diameter: 3mm, outside diameter: 5mm. Operating
g pressure maximum 7.5 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 4mm, outside diameter: 6mm. Operating
g pressure maximum 6,0 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 5mm, outside diameter: 7mm. Operating
pressure maximaum 7.0 bar. By meters. Custom cut, return not possible!
For windshield open mechanism. Suitable for Citroen 11CV + 15CV, up to year of construction
07/1952. Or. No. 804110
Trim set for the doors (4 fittings). Suitable for Citroen 11CV BL + 15CV. The trim are produced
from aluminum. Or. No. 802942
Knob "D" for starter motor Bowden cable. Suitable for Citroen 11CV, 15CV, 2CV old, HY. The handle
is oval and from aluminum.
Ignition cable set, suitable for Citroen 11CV. Citroen HY, up to model year 1963. Or. No. 715024
Caution: These ignition cables are high-resistance and can only be used with low-resistance spark plugs (so no spark plugs with an R in the designation. R = cadio-control = high resistance).
Spark plug NGK BP6 HS. Suitable for all Citroen DS models, Citroen HY, Citroën Traction 11cv and
15six. Short thread. Thread: M14 x 1.25 x 10mm. Wrench 21mm.
Spark gap measurement (testing) tool. With the help of this small, inexpensive tool, the spark gap
of the spark plug can be checked very easily and safely. So, if the engine does not start: Is the spark plug sparking at all! And if so, how strong! Then exclusion procedure: Ignition OK? It is not getting any petrol!
Flexible Spark Plug Remover/Installer. This specially designed tool allows access to spark plugs
where they are deep seated or require off-line access. The tool is also designed to grip the spark plug securely allowing the removal with ease.
Heli coil spark plug thread repair set. For all M14 spark plugs. Contents: 1 bore + cutting tool
installation spindle. 10x heli coil insert M14x1,25x17,5. (Spark plugs with long threads). 10x heli coil insert M14x1,25x12,7. (Spark plugs with short threads, 2CV, R4).
Spark plug thread M14 thread inserts. Suitable for our repair kit 21176. Length of thread inserts
9.7 mm + 11.0 mm + 13.0 mm + 19.1 mm.
Spark plug thread M14 cleaner, with a cutter for the spark plug sealing ring. This combination tool
can clean your contaminated thread and make it usable again. In addition, the sealing surface around the thread is nicely planed again. But be careful: if the spark plug thread is already badly damaged, you will need to insert a new thread (item 21176).
Spark plug thread M14 repair kit (for repairing defective spark plug threads). Hobby quality. For
all M14 spark plugs. The repair kit comes with an HSS thread cutter (drive wrench size 17 mm) and 4 thread inserts. Length of thread inserts: 9.7 mm + 11.0 mm + 13.0 mm + 19.1 mm.
Spark plug wrench (adjustable in length), for 20,8mm spark plugs. This key is perfect for the
Citroen DS. It can be used with the normal electrode extension. Fitting for 3/8 inch ratchet (medium size). Fits of course also on all other spark plugs, for 21mm tools. Manufacturer: HAZET. Adjustable length from: 137,5mm to 157,5mm and 195,5mm. With spark plug holding rubber.
Spark plug wrench (tube wrench), for 20.8 mm spark plugs. 300mm long! Particularly for Citroen DS
Peugeot 203, 403, 404, 504. Workshop quality!
1262 Articles | Page 25 of 26
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
