for Citroën SM

Zinc primer, 400ml.

Spark plug NGK BP6ES. Suitable for Citroen GSA, Citroen SM IE. Peugeot 505. Renault R16, R17, R18

Thread M14x1,25. Wrench: 21mm. Length of thread: 19mm. For the mounting from a electrode extension.

• Suitable for this article
• 
  Flexible Spark Plug Remover/Installer. This specially designed tool allows
  14,78 €

Spark gap measurement (testing) tool. With the help of this small, inexpensive tool, the spark gap

of the spark plug can be checked very easily and safely. So, if the engine does not start: Is the spark plug sparking at all! And if so, how strong! Then exclusion procedure: Ignition OK? It is not getting any petrol!

Flexible Spark Plug Remover/Installer. This specially designed tool allows access to spark plugs

where they are deep seated or require off-line access. The tool is also designed to grip the spark plug securely allowing the removal with ease.

Tap drill M14x1,25. (Spark plug threads).

• Suitable for this article

Heli coil spark plug thread repair set. For all M14 spark plugs. Contents: 1 bore + cutting tool

installation spindle. 10x heli coil insert M14x1,25x17,5. (Spark plugs with long threads). 10x heli coil insert M14x1,25x12,7. (Spark plugs with short threads, 2CV, R4).

Spark plug thread Helicoil insert. M14x1,25x12,7 (spark plugs with short thread 2CV, R4). Refill

package (10 pieces)!

Spark plug wrench (tube wrench), for 20.8 mm spark plugs. 300mm long! Particularly for Citroen DS

Peugeot 203, 403, 404, 504. Workshop quality!

Spark plugs plug 90° bent.

Starter lock blank key. Suitable for Citroen Acadiane from year of construction 1978 to 1987. Dyane

from 1967 to 1979. Citroen SM. AMI6 from 1961 to 1969. AMI8 from 1969 to 1979. CX from 1981 to 1984. GS starting from 1970. For starter lock manufacturers: VACHETTE. Please note the cross section of the key bit. Shaft length: 32,80mm. Shaft width: 7,6mm.

Spark Indicator. This non-contact spark tester will test for the presence of power in spark plugs

coils and distributors. Simply place the grooved end over the spark plug wire with the engine running and the high intensy bulb will flash indicating spark. Note: Depending upon screen of the ignition cables, it can be possible, that you see the flashing by daylight, very bad!

Brake cylinder hone. For use with a cordless drill to clean brake cylinders during service

22-69mm. For honing out brake cylinders. For use with a standard drill.

• Suitable for this article
• 
  Hone segment 30x4mm (2 fittings) for brake cylinder hone 20916.
  9,27 €

Engine cylinder hone. Enables the inside surface of the cylinders to be cleaned of carbon deposits

etc. Suitable for all cylinders with a bore diameter of 50

• Suitable for this article
• 
  Hone segment 100x10mm (3 fittings) for engine cylinder hone 20918.
  20,81 €