Rust eraser pen. Ideal for removing even the smallest rust spots. Indispensable! And, of course
the cleaned rust spot must then be preserved with paint immediately.
special tools for motor vehicles for Sonstige-Citroen Xantia
77 Articles | Page 2 of 2
Discs (windscreen) Pull-in tool (cord with handle). This is used to pull the rubber lip of the seal
over the sheet metal fold. Very helpful!
Windscreens (windscreen) piping assembly tool - bracket inserts. For small piping. There are 5
brackets in different widths so that narrow and wide piping can be fitted (e.g. for the 2CV, R4....). Suitable for tool with item number 20134.
Windscreen Installation Tool Set. Windshield sealing trim assembly tool. With this tools will the
rubber lip (seal) inclination (spread) and it can fit the sealing trim at the same time. Attention: The tool is for very wide piping. For chrome piping e.g. Citroen 2CV, Renault R4 etc. small brackets must be fitted. See our item number 20137.
Trakrite Wheel Alignment Gauge. Trakrite is the simplest, most accurate device for checking the
alignment of the steered wheels of car and light commercials. It is a roller bearing platform over which one front wheel is slowly driven with the wheels in their straight ahead position.
Temperature indicator (laser), electronic, ideal for motor vehicle sector for instance to check on
elbow wether all cylinders are working optimal or to check water temperature, etc. Very easy to use, good quality professional product!
Separation Fork Set, 5 pcs., forged carbon Steel 3 forks opening: 17,4 mm - 23,8 mm - 28,5 mm. 1
1 handle 200 mm long. 1 adapter for impact hammer 10 mm shaft-ø, 175 mm long.
Transfer pump metal version, inclusive 2 hoses for drawing in and running off, 500ccm. Applicable
e for: Diesel, fuel oil, coolant, brake fluid.
Valve grinding-in paste (engine valves in the cylinder head), 100ml box. The double box contains
pre-grinding paste (rough) and regrinding paste (fine).
- Suitable for this article
Flexible Spark Plug Remover/Installer. This specially designed tool allows access to spark plugs
where they are deep seated or require off-line access. The tool is also designed to grip the spark plug securely allowing the removal with ease.
Heli coil spark plug thread repair set. For all M14 spark plugs. Contents: 1 bore + cutting tool
installation spindle. 10x heli coil insert M14x1,25x17,5. (Spark plugs with long threads). 10x heli coil insert M14x1,25x12,7. (Spark plugs with short threads, 2CV, R4).
Spark plug wrench (tube wrench), for 20.8 mm spark plugs. 300mm long! Particularly for Citroen DS
Peugeot 203, 403, 404, 504. Workshop quality!
Spark Indicator. This non-contact spark tester will test for the presence of power in spark plugs
coils and distributors. Simply place the grooved end over the spark plug wire with the engine running and the high intensy bulb will flash indicating spark. Note: Depending upon screen of the ignition cables, it can be possible, that you see the flashing by daylight, very bad!
Brake cylinder hone. For use with a cordless drill to clean brake cylinders during service
22-69mm. For honing out brake cylinders. For use with a standard drill.
Engine cylinder hone. Enables the inside surface of the cylinders to be cleaned of carbon deposits
etc. Suitable for all cylinders with a bore diameter of 50
77 Articles | Page 2 of 2
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
