Alle / Alle / rear axle

Nut, for the wheel hub rear axle. Suitable for Citroen DS. Thread: H25 x 150. Or. No. 0D5404980H

Quality: 3

P 203/403, bonded-rubber bushing anti roll bar rod rear straight over the rear axle. Peugeot 203 + 403. 12x30x30x24mm

Quality: 3

P 203/403/404/504, oil restraint coil, rear axle tube on the right. Suitable for Peugeot 203, 404, 404 + 504. Outside diameter: 61,12mm. Inside diameter: 40,2mm. Marking: white. Or. No. 3045.17

Quality: 3

P 203/403/404/504, shaft seal for the bearing of the full-floating axle. Dimension: 52 x 75 x 12mm. Suitable for Peugeot 203, 403, 404, 504. Or. No. 3345.09

Quality: 3

P 204, rubber stop rear axle, Peugeot 204. Or.Nr. 516610. The sheet metal plate has a diameter of 55mm, M8 thread, height about 47mm.

Quality: 3

P 204/304/404/504, rear axle rubber stop. Diameter: 55mm. Height: 53mm. Suitable for Peugeot 204, 304, 404, 504. Or. No. 3514.12

Quality: 3

P 403/404/504, bonded-rubber bushing mounting plate spring at the rear axle, Peugeot 403, Peugeot 404 + 404 Pick UP, Peugeot 504 Pick UP. Measurements inside 16mm, outside 32mm. Length inside 54mm, outside 50mm

Quality: 3

P 404, rear axle rubber stop. Suitable for Peugeot 404. Or. No. 3514.09

Quality: 3

wheel bolts Peugeot 404 M12x1, 25x35, till 1968

Quality: 3

P 404, shaft seal differential. Dimension: 27 x 47.2 x 8mm. Suitable for Peugeot 404.

Quality: 3

P 404/504, bonded-rubber bushing for the anti roll bar ouple rod (rear axle). Suitable for Peugeot 404 + 504. Inside diameter: 10mm. Outside diameter: 27mm. Or. No. 5179.02

Quality: 3

P 404/504, Panhard rod + anti roll bar repair set, for the rear axle. Suitable for Peugeot 404 BREAK + Pick UP. Peugeot 504 sedan, Coupe, Cabriolet. 504 BREAK + Pick UP. Bonded-rubber bushing: Ø 12 x Ø 30mm, length 42 x 36mm (5171.01). Screw: M12x70mm (5173.03). Nut M12 (3431.01).

Quality: 3

Shaft seal for bearing knockout spindle, Peugeot 404/504. 45x62x10mm, Or.Nr.334510

Quality: 3

P 404/504, stud bolt suspension spring rear. M12x1,5. 112mm lengthens. Suitable for Peugeot 404 + 504

Quality: 3

P 404/504/505, bonded-rubber bushing, for the fixture plate spring rear axle. Suitable for Peugeot 404, 504, 505. Inside diameter: 16mm. Outside diameter: 32mm. Length inside: 69mm. Length outside: 60mm. Or. No. 5131.39

Quality: 3

P 404/504/505, shaft seal (with metal inset) for the wheel hub rear (full-floating axle). Dimension: 53 x 79 x 10mm. Suitable for Peugeot 404, 504, 505. Or. No. 3345.31

Quality: 3

P 504, bonded-rubber bushing for the wishbone (rear axle). Suitable for Peugeot 504 sedan, Cabrio, Coupe. Inside diameter: 16,0mm. Outside diameter: 32mm. Or. No. 5131.17

Quality: 3

P 504, bonded-rubber bushing triangle rear axle. Diameter inside: 14mm. Outside diameter: 29mm. Length inside: 44mm. Length outside: 32mm. Suitable for Peugeot 504. Or. No. 3523.12

Quality: 3

P 504/505, wheel bolt. Thread: M12 x 1,25. Length of thread: 38mm. Suitable for Peugeot 504 + 505, which have brake disks at the rear axle. Or. No. 3311.13

Quality: 3

• Suitable for this article
• P 504, wheel nut. Thread: M12 x 1,25mm. Suitable for Peugeot 504. Or. No. 5405.31
  1,83 €

P 504/505, shaft seal for the differential. Dimension: 45 x 62 x 10,5mm. Suitable for Peugeot 504 sedan + Cabrio (also V6). Peugeot 505. Or. No. 3121.13

Quality: 3

P 504/505, anti roll bar rod rear. Suitable for Peugeot 504 Break + 505 Break. Or. No. 5178.05

Quality: 3

P 504/505/604, mounting (fixture) rear axle, on the left (rubber metal handle). Dimension: 45 x 69 x 44mm. Suitable for Peugeot 504, 505, 604. Or. No. 5152.16

Quality: 3

P 504/505/604, mounting (fixture) rear axle, on the right (rubber metal handle). Dimension: 45 x 69 x 44mm. Suitable for Peugeot 504, 505, 604. Or. No. 5152.17

Quality: 3

P 504/505/604, anti roll bar rod, rear axle. Suitable for Peugeot 504 sedan (apart from Luxe), 504 Cabriolet + Coupe. 505 sedan, 604. Length over everything: about 175mm. Or. No. 5178.03

Quality: 3

P 504/505/604, Alpine A310. Mounting (fixture) rear axle (rubber metal handle). Dimension: 69 x 40mm. Heavy one: 24/38mm. Suitable for Peugeot 504, 505, 604. Renault Alpine A310. Or. No. 5152.18

Quality: 3 360°

R16, rubber for the anti roll bar rear. Per piece. Suitable for Renault R16. Or. No. 0855607800

Quality: 0

R16, rear axle radius arm repair set. For both sides. Suitable for Renault R16. Or. No. 0981692400 + 0981692401

Quality: 3

R16, metal sleeve in the radius arm rear, for the mounting of the rubber bushing (83322). Suitable for Renault R16. Or. No. 0981693200.

Quality: 3

• Suitable for this article
• R16, repair set (rubber bearing, per side) for the radius arm bearing rear, inside the rear axl
  108,09 €

R16, repair set (rubber bearing, per side) for the radius arm bearing rear, inside the rear axle. Suitable for Renault R16. Note: The metal sleeve in the radius arm should be absolutely exchanged. Our number: 84328.

Quality: 3

• Suitable for this article
• R16, metal sleeve in the radius arm rear, for the mounting of the rubber bushing (83322). Suita
  42,54 €

R16, anti roll bar tie bar, at the rear axle. Suitable for Renault R16. Per piece. Or. No. 0833109900

Quality: 3

R4, fixing screw Torx (6x14), for fixing the brake drum on the wheel hub. Suitable for Renault R4. Or. No. 7703004077

Quality: 3

R4, Torsion bar mounting rear on the right. Finetoothed. Original Renault, no reproduction. Suitable for Renault R4.

Quality: 0

R4, Rear axle mounting on the left (with bonded-rubber bushing. Suitable for Renault R4. Case inside diameter: 49 mm. Inside diameter bonded-rubber bushing: 34 mm.

Quality: 3 360°

• Suitable for this article
• R4, Rear axle mounting on the right (with bonded-rubber bushing. Suitable for Renault R4. Case
  29,66 €

R4, Rear axle mounting on the right (with bonded-rubber bushing. Suitable for Renault R4. Case inside diameter: 49 mm. Inside diameter bonded-rubber bushing: 34 mm.

Quality: 3 360°

• Suitable for this article
• R4, Rear axle mounting on the left (with bonded-rubber bushing. Suitable for Renault R4. Case i
  29,66 €

R4, radius arm mounting inside, at the rear left. Suitable for Renault R4. Or. No. 0832108100

Quality: 4

• Suitable for this article
• R4, radius arm mounting inside, at the rear right. Suitable for Renault R4. Or. No. 0832108200
  98,18 €

R4, radius arm mounting inside, at the rear right. Suitable for Renault R4. Or. No. 0832108200

Quality: 4

• Suitable for this article
• R4, radius arm mounting inside, at the rear left. Suitable for Renault R4. Or. No. 0832108100
  98,18 €

R4, radius arm mounting, at the rear left (radius arm-laterally, triangular with bonded-rubber bushing). Suitable for Renault R4. Or. No. 0832108100

Quality: 5

• Suitable for this article
• R4, radius arm mounting, at the rear right (radius arm-laterally, triangular with bonded-rubber
  118,01 €

R4, radius arm mounting, at the rear right (radius arm-laterally, triangular with bonded-rubber bushing). Suitable for Renault R4. Or. No. 0832108200

Quality: 5

• Suitable for this article
• R4, radius arm mounting, at the rear left (radius arm-laterally, triangular with bonded-rubber
  118,01 €

R4, Radius arm holder (cross-beam) at the rear left. With section, of the outer limit cross-beam (without bonded-rubber bushings)! Suitable for Renault R4. Made in Europe.

Quality: 4

• Suitable for this article
• R4, Rear axle mounting on the left (with bonded-rubber bushing. Suitable for Renault R4. Case i
  29,66 €
• R4, Radius arm holder (cross-beam) at the rear right. With section, of the outer limit cross-be
  69,32 €

R4, radius arm holder (cross-beam) at the rear left. Very good quality. With section, of the outer limit cross-beam (without bonded-rubber bushings)!Suitable for Renault R4. The sheet metal are galvanically treated with cataphoresis.

Quality: 3

R4, Radius arm holder (cross-beam) at the rear right. With section, of the outer limit cross-beam (without bonded-rubber bushings)! Suitable for Renault R4. Made in Europe.

Quality: 4

• Suitable for this article
• R4, Rear axle mounting on the right (with bonded-rubber bushing. Suitable for Renault R4. Case
  29,66 €
• R4, Radius arm holder (cross-beam) at the rear left. With section, of the outer limit cross-bea
  69,32 €

R4, radius arm holder (cross-beam) at the rear right. Very good quality. With section, of the outer limit cross-beam (without bonded-rubber bushings)!Suitable for Renault R4. The sheet metal are galvanically treated with cataphoresis.

Quality: 3

R4, bonded-rubber bushing (2 fittings) for the bearing of the rear axle rocker (per side). Suitable for Renault R4.

Quality: 3

R4, Silent bush (per piece) for the bearing of the rear axle rocker. Suitable for Renault R4. Dimensions ca.: Outer diameter 55mm and 42mm, inner diameter approx. 37,5-38mm, length over all 59mm.

Quality: 3

R4, bonded-rubber bushing (per piece) for the bearing of the rear axle rocker. Suitable for Renault R4. Dimension inside: 27mm. Outside: 45mm. Length: 65mm + 27mm.

Quality: 3

R4/R5, bonded-rubber bushing (2 fittings) for the bearing of the rear axle rocker. Suitable for Renault R4, R5, R6, Alpine A110. Inside diameter: 34mm. Outside diameter: 50mm. Length inside: 45mm. Length outside: 39,5mm.

Quality: 3

R5, Rear axle mounting on the left (with bonded-rubber bushing. Suitable for Renault R5. Or. No. 77006557. Silent bush: Inner diameter 35.5mm. Outer diameter: 62.0mm. Length bush: 50mm.

Quality: 3

R5, Rear axle mounting on the right (with bonded-rubber bushing. Suitable for Renault R5. Or. No. 77006558. Silent bush: Inner diameter 35.5mm. Outer diameter: 62.0mm. Length bush: 50mm.

Quality: 3

R5, bonded-rubber bushing (2 item) for the rear axle (inside). Suitable for Renault R5 (1 series), of year of construction 10/1972 to 09/1984. R6 of year of construction 10/1969 to 04/1980. Inside diameter: 34mm. Outside diameter: 50,0mm. Length inside: 45,0mm. Length outside: 39,50mm. Or. No. 0855599000

Quality: 3

Wheel bolt rear (in the drum), suitable for Citroen 2CV. Made in Germany!

Quality: 3