Brake caliper sealing set. Suitable for Citroen 2CV, LHM system. Consisting of: 2 x seal + 2x dust
bag for the pistons, seal between the brake caliper halves, connecting tube brake caliper halves. Now improved version from Denmark!
for Citroën 2CV Dyane
2024 Articles | Page 9 of 41
Brake caliper seal (for sealing the two brake caliper halves) for our brake caliper 13013
Dimensions: 10 x 6.2 x 1.9 mm, suitable for Citroën 2CV, Dyane, AMI. Please note: Only suitable for our reproduction brake calipers 13013.
Brake caliper seal (for sealing the two brake caliper halves). Dimensions: 11 x 7.0 x 2.0mm
suitable for Citroën 2CV, Dyane, AMI. Please note: Only suitable for original brake calipers. Not suitable for reproduction brake calipers.
Front brake calliper, complete. New part! Suitable for Citroen 2CV, from year of construction 1981
to year of construction 1990 (8mm brake line screw connection). No old part return required! Attention: A 3mm washer must be used for the mounting screws (our number 1300) or continue to use the original washers. Without these 3mm washers, the fastening screws are too long!
Brake caliper halves connecting tube. Suitable for Citroen 2CV, starting from year of construction
1981. Caution, it gives also brake calipers, which were sealed between the halves only with an O-ring!
Brake disks "sport" front (2 pieces). Suitable for Citroen 2CV, from year of construction 1981 up
to 1990. The brake disks are perforated and have more brake power. The disks are particularly for operating tow trailer, 2CV van (if heavily loaded) etc. In normal driving mode, a conversion is not necessary.
Brake disks in front (2 fittings). Suitable for Citroen 2CV. Installed from year of construction
1981 to 1990. Reproduction.
Brake disks in front (2 pieces). Suitable for Citroen 2CV. Installed from year of construction 1981
to 1990. Original manufacturer quality. Of it their safety is dependant. Be careful: If the brake discs are installed at the front of your car: Just use hydraulic fluid LHM as brake fluid and never DOT4! DOT4 can destroy within 24hours the hole brake system. That is expensive und very dangerous. Every LHM brake part is green marked.
Brake hose mounting plate, rear left. Fits Citroen 2CV, up to year of manufacture 07/1964. The
brake hose is attached to the bracket with the banjo bolt (hence the 10mm hole in the bracket). Reproduction. Or. No.: A453-67
Brake hose mounting plate, rear left. Suitable for Citroen 2CV, from year of manufacture 07/1964 to
01/1972. The brake hose with its M14 thread is pushed through the holder and locked with a thin M14 nut (hence the 16mm hole)! Made of stainless steel! Or. No. AM453-67. Made in Germany.
Brake hose mounting plate, rear right. Suitable for Citroen 2CV, from year of manufacture 07/1964
to 01/1972. The brake hose with its M14 thread is pushed through the holder and locked with a thin M14 nut (hence the 16mm hole)! Made of stainless steel! Or. No. AM453-67A. Made in Germany.
Brake hose mounting plate, rear right. Fits Citroen 2CV, up to year of manufacture 07/1964. The
brake hose is attached to the bracket with the banjo bolt (hence the 10mm hole in the bracket). Reproduction. Or. No.: A453-67A
Brake hose rear, suitable for Citroen 2CV + AMI6, to year of construction 1966. Length: 310mm. One
side male thread M10x1. The other side has a female thread M10x1.
PDF FILE 
Brake hose rear, suitable for Citroen 2CV, starting from year of construction 1966. Length: 304mm
Both sides male thread M14x1,5 with additional female thread M9x1,25. Or. No. AM453-35
Brake hose in front, suitable for Citroen 2CV, to year of construction 07/1964. Length: 285mm. One
side male thread M12x1. The other side has female thread M10x1. Or.Nr.: AM453-29 AV. Made in Spain.
Brake hose in front, suitable for Citroen Dyane 6, Mehari. Length: 222mm. One side male thread
M12x1. The other side has a male thread M14x1,5 with additional female threads M9x1,25. Made in Spain.
Brake drum rear (new part), with mounted wheel bearing. The brake drum is ready for assembly
mounted. Consisting of: New brake drum, new wheel bearing, new shaft seal, new wheel bearing screw. Suitable for Citroen 2CV.
Drum rear, new part. 180mm diameter. Suitable for Citroen 2CV, Dyane, ACDY, Mehari. The drum is
supplied without wheel bearings. Or. No. 96995256
Drum in front. Suitable for Citroen 2CV. 200mm diameter, 4x securement. The drum is outside ripping
(small drum, not suitable for 2CV Van). Per piece.
Drum in front. Suitable for Citroen 2CV. 200mm diameter, 6x securement. The drum is outside ripping
(small drum, not suitable for 2CV Van). Per piece.
Drum in front. Suitable for Citroen AK400, 350, AMI6, Dyane. 4 hole securement. 220mm diameter. The
drum is outside ripping. Or.No.: AM4516
Brake cylinder paste. Manufacturer: FÖRCH. 5g brake cylinder paste for hydraulic brake systems
For lubricating cylinder liners and pistons. Extends the service life of brake cylinders. Protects against corrosion. Compatible with DOT 3, DOT 4 and DOT 5.1 brake fluids. Keeps sleeves soft. Supports the installation of O-rings, lip seals, sleeves and other sealing elements made of rubber-elastic materials. Apply brake cylinder paste thinly and evenly on the surfaces to be lubricated. Attention: If you are installing a new wheel brake cylinder in your classic car, please coat the pistons and sleeves with this paste before installation. This will increase the longevity of the new brake parts on cars that are driven occasionally.
Chassis drive shaft plate left (left wing), as replacement (to weld in) for the original Citroen
2CV chassis, from year of construction 05/1971. Or. No. AY721-106A
Chassis drive shaft plate right (right wing), as replacement (to weld in) for the original Citroen
2CV chassis, from year of construction 05/1971. Or. No. AY721-104B
Securement package largely for chassis 2CV6 with drum brake! Consisting of: 1x screw fixing set
body on chassis, brake + fuel line brackets, 1x lasering of the chassis number into the chassis, 1x brake line set stainless steel, 1x DOT brake fluid, 4x threaded pipe fixing for suspension pot in chassis, 8x nut for threaded pipe, 4x locking plate for axle mounting screws, 1x grease tape 10 meter sealing body to chassis, 4x shock absorber bolts, 8x axle mounting screw
Securement package largely for chassis 2CV6 with disc brake! Consisting of: 1x screw fixing set
body on chassis, brake + fuel line brackets, 1x lasering of the chassis number into the chassis, 1x brake line set stainless steel, 1x LHM brake fluid, 4x threaded pipe fixing for suspension pot in chassis, 8x nut for threaded pipe, 4x locking plate for axle mounting screws, 1x grease tape 10 meter sealing body to chassis, 4x shock absorber bolts, 8x axle mounting screw
Front cross member, as replacement (to be welded in) for the original Citroen 2CV chassis, from
year of construction 05/1971. Or. No. 6A 5411 280L
Chassis reinforcement in the chassis (oval plate), as a replacement (for welding in) for the
original Citroen 2CV chassis, from year of manufacture 05/1971.
Chassis, completely galvanized, 11 years guarantee! For Citroen 2CV. For vehicles with disc brake
ke. Made in Germany according to ISO 9001:2008, homolagated! - over 6800x delivery! Seasonally it can come to delivery times of up to 14 days! The chassis are produced here in our town Vechta. All threads were re-cut after galvanizing.
Choke cable old version, without light. Suitable for Citroen 2CV, Dyane, AMI6+8 until 1976, length
to 1500mm (can be shortened)
Choke cable, final version for Citroen 2CV + Dyane. For the square mounting. The choke cable is
illuminated! Or. No. 95597858
VIDEO Autosol chrome polish. 75 ml tube. (Premium chrome shine care). Autosol chrome polish has been
around for ages and has often been copied! Made in Germany.
Citroen emblem (Chevron) on the dashboard. Suitable for Citroen 11CV + 15CV, up to year of
construction 02/1952. Or. No. 802594. Dimension: 38 x 40mm. The emblem can also be used universal.
2024 Articles | Page 9 of 41
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
