for Citroën 2CV Dyane
2024 Articles | Page 12 of 41
Dyane, disk seal vertically, between the sliding and the firmlyglass disk. For the door in front (1
side with velvet). Suitable for Citroen Dyane. Or. No. AM961-129c
Dyane, sliding window rubber seal (guide of the disks), for the front doors. Suitable for Citroen
Dyane. The rubber are after-fabricated in high quality. Length: 330cm (enough for one door). For a Dyane, you need only 200cm, but we can buy in only 330cm. Because the rubber is identically with Renault Camionette. Or. No. AY961-72A + AY961-73A.
Dyane, lockcylinder set (3 fittings), for the doors. Suitable for Citroen Dyane. If you liked to
use the locks at a ACDY (Dyane Van), you need for the tail gates a lockcylinder set from the 2CV. (16036)
Dyane, box sill on the left, for Citroen Dyane. It is only the outer sheet metal, and not the
complete box sill. Made in Europe.
Dyane, box sill on the right, for Citroen Dyane. It is only the outer sheet metal, and not the
complete box sill. Made in Europe.
Dyane, seat bench box completely, for Citroen Dyane. Or.Nr. AY831-202A Measurements of the box
135x28x17cm. Made in Europe.
Dyane, seat bench box repair sheet metal in the interior, sheet metal strengthened. The sheet metal
is supplied without outer seat bench box corner. Made in Europe.
Dyane, clamping strap for the intermediate bottom (spare wheel cover) in the luggage compartment
Suitable for Citroen Dyane. Or. No. AY832-110
Dyane, front wall for Citroen Dyane. The warm air connecting pieces must be taken over by the old
front wall! Or.Nr. AY833-01
Dyane, strut for the front fender. The strut fits on the left or right. Suitable for Citroen Dyane
from year of manufacture 04/1971. Original no. 1Y 5411 367G. The strut is made of stainless steel!
Dyane, door seal rear (on the left of or on the right suitable). For Dyane starting from year of
construction 1970. Length: 3050mm. The seal has a metal core!
Dyane, door seal in front (on the left of or on the right suitable). For Dyane + ACDY, starting
from year of construction 1970. Length: 3300mm. The seal has a metal core!
Door check strap, door in front + rear fitting. For Citroen Dyane starting from 02/69, Acadyane
Mehari. Or. No. AY84216
Dyane, door lock inside, front left. Suitable for Citroen Dyane. Not suitable for Acadiane with
crank windows (sliding windows only!)
Dyane, door lock inside, front right. Suitable for Citroen Dyane. Not suitable for Acadiane with
crank windows (sliding windows only!)
Dyane, door lock, lock latch left, body side (mounted on the B-pillar + C-pillar). Suitable for
Citroen Dyane + ACDY (only on the B-pillar)
Dyane, door lock, lock latch left, body side (mounted on the B-pillar + C-pillar). Suitable for
Citroen Dyane + ACDY (only on the B-pillar)
Dyane, connecting plate for the front sheet metal to the chassis. Suitable for Citroen Dyane +
ACDY. Or. No. AY853-111
Dyane, windshield frame bottom plate (reinforcement, inside. Upper internal sheet metal above at
the dashboard). Suitable for Citroen Dyane. Made in European Union.
Dyane, trim strip for the rain gutter (2 pieces). Very good reproduction from Europe, like
original. Suitable for Citroen Dyane.
ACDY/DYANE, pedal floor plate complete for Citroen Dyane + ACDY. The pedal base is optical a
reproduction and like the original sheet metal (with all flanges). The pedal base is produced of heavier sheet metal and electrolytically galvanized. Made in Europe.
Dyane/Mahari, left headlight housing, made of metal. Suitable for Citroen Dyane and Mehari. This
headlight housing is finally available again. It was used in the early years of construction for the Dyane (until 1978) and Mehari. After that, a model change was made and the headlight housings were switched to plastic.
Dyane/Mahari, right headlight housing, made of metal. Suitable for Citroen Dyane and Mehari. This
headlight housing is finally available again. It was used in the early years of construction for the Dyane (until 1978) and Mehari. After that, a model change was made and the headlight housings were switched to plastic.
Headlight mounting bolt (stud bolt with ball head 5mm). Thread: M5 x 0.8. Length: approx. 34 mm
The bolt is slotted at the end so that the headlight height can be adjusted with a screwdriver. Suitable for Citroen Dyane + Mehari. However, this bolt has also used in many French vehicles (Renault R4, Dauphine, Peugeot 203, 403, 404, etc.).
2024 Articles | Page 12 of 41
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
