for Peugeot J5

Rubber bearing for wishbone Citroen C25, Peugeot J5, Fiat Ducato. On the left of or on the right

fitting. Inside diameter of 18mm, outside diameter 34mm, height of 40,6mm. Or. No. Fiat 4331968

J5/C25, master brake cylinder sealing set for 22,2mm piston, brake system Bendix. Suitable for

Peugeot J5, Citroen C25.

• Suitable for this article
• 
  Brake cylinder paste. Manufacturer: FÖRCH. 5g brake cylinder paste for
  5,31 €

J5/C25, air filter A847. Suitable for Citroen C25 Diesel (2,5D), starting from year of construction

10/1983. Peugeot J5 Diesel (2,5D), starting from 10/1983. Outside diameter: 140mm. Height: 296mm. Or. No. 1444.01

J5/C25, repair set brake caliper, brake system Lucas. 38/48mm. Suitable for Peugeot J5, Citroen C25.

Wheel bearing oil-seal-ring size 69x85x10. Peugeot J5, Boxer, Citroen C25, Jumper.

J5/C25, tie rod without tie rod end, on the left + on the right fitting. Thread M16 x 1,5. Citroen

C25 + Peugeot J5, without power steering. Installed to year of construction 1990. Or. No. 381227

Tie rod end Citroen C25, Peugeot J5, Fiat Ducato. Starting from year of construction 1981, on the

left + on the right fitting. Thread M16x1,5, right-hand thread.

J5/C25. Heater radiator (heat exchanger) suitable for Peugeot J5 + Citroen C25. Installed from year

of construction 10/1985 to 03/1994. Length: 243mm. Wide one: 177mm. Deep 42mm.

Brake pads in front Peugeot J5, Citroen C25 + C35, Ducato. Heavy 19,5mm, height of 71,7mm, wide one

144,9mm. Brake system Lucas!

J5/C25/Ducato, radiator expansion tank. Suitable for Citroen C25, Peugeot J5, Fiat Ducato. Or. No

1303.78 + 4431399

J5, C25, Ducato, headlamp H4 on the left, without headlamp leveling regulation. Or. No. 6204A7

7

J5, C25, Ducato, headlamp H4 on the right, without headlamp leveling regulation. Or. No. 6205A8

8

J7, starter motor. Suitable for Peugeot J7 (1.6 petrol), of year of construction 8/1968 to 07/1970

9 teeth. Direction of rotation in in the clockwise direction. 2 securement.

J7, bonded-rubber bushing front axle Peugeot J7. Measurements: 16 x 36 x 47 x 36

J7, front axle wishbone fixture (bonded-rubber bushing). 8 item. Suitable for Peugeot J7 + J9.

P J7/J9, brake shoes to rivet. 300mm diameter, 55mm wide. Rear axle. Or. No. 424578

J7/J9, brake pads in front, system Bendix. Suitable for Peugeot J7 + J9. Wide one: 144mm

mm. Thickness: 58mm. Heavy one: 15mm.

Ball pin above (ball-and-socket joint), Peugeot J7, J9. Per piece!

Ball pin down (ball-and-socket joint), Peugeot J7, J9. Per piece!

J7/J9, repair set for Bendix brake caliper. Suitable at the front axle for Peugeot J7 + J9

starting from year of construction 1968. Piston diameter: 48mm. Delivery without pistons. Label manufacturer!

J7/J9, repair set for Bendix brake caliper. Suitable at the front axle for Peugeot J7 + J9

starting from year of construction 1968. Piston diameter: 48mm. Delivery without pistons.

Popular assortment of rubber Wiring & Blanking grommets. Wiring Grommets from 6mm to 16mm. Blanking

Grommets from 8mm to 25mm. Box Qty 240

V-belt 10x1000. Suitable for Peugeot 404 (Paris Rhone + SEV alternating current, Injection

starting from FIN: 8.239.302 sedan, starting from 6.800.743 Coupe Cabriolet). 504, 505, 605, J7 (generator). Citroen CX 2000-2200 (generator). Renault R18, 20, 21, Espace, master (generator).

V-belt size: 10x1025, Peugeot 505 2,5TD, J7 +9 2,1D, R25 2.0, Master, for generator.

V-belt 10x1225. Suitable for Peugeot 404 Diesel (Paris Rhone + SEV - direct current, 5750,23). J9

(generator). Renault R12.

V-belt 10x600mm. Suitable for Citroen DS + CX (centrifugal governor). Peugeot 505 2,5D + J5 2,5D

(Vacuum pump). Renault R5 (generator).

V-belt size: 10x613, Peugeot 205, 305, 309 for power steering pump. Peugeot 505 2,5TD + J5 1,9D for

vacuum pump!

V-belt 10x700. Suitable for Peugeot 404, 504, J5. Citroen CX, C25. Renault R4 (direct current), R5.

V-belt size: 10x825, Peugeot J5 + Citroen C25 water pump.

V-belt 10x860. Suitable for Renault R12 Gordini (generator). Renault R20 1.6 (servo pump). Peugeot

505 2,2TI (servo pump). Peugeot J9 (generator).

V-belt 10x887. Suitable for Peugeot 504, J9D (generator). Citroen C25 petrol (water pump).

V-belt 10X925. Suitable for Citroen DS, of year of construction 1961 to 1967 (water pump, old

engine with 3 crankshaft bearings). Citroen C25. Peugeot 205 1.0-1.1. Peugeot 505 2,2. Peugeot J5 petrol (generator).

V-belt 9,5x675. Suitable for Renault R4 (845cc) generator. R6 (845cc), Dauphine Gordini, R5TL, 4CV

Peugeot J7 + J9 petrol for the generator. Citroen CX. Length: 675mm

V-belt for the generator. Dimension: 10 x 1300. Suitable for Citroen HY, of year of construction

1963 to 1968. Peugeot J9 Diesel. Or. No. HY231-6

Rocker switch for the heater blower (1 speed). 33x5x19.5mm (installation dimension). Suitable for

many Renault and Peugeot models.

Rocker switch warning signal light. 33x5x19.5mm (installation dimension). Suitable for many Renault

and Peugeot models.

Ratchet adapter (enlargement). From 1/4 ratchet to 3/8 socket wrench.

• Suitable for this article
• 
  Ratchet adapter (enlargement). From 3/8 ratchet to 1/2 socket wrench.
  22,71 €

Ratchet adapter (enlargement). From 3/8 ratchet to 1/2 socket wrench.

• Suitable for this article
• 
  Ratchet adapter (enlargement). From 1/4 ratchet to 3/8 socket wrench.
  18,74 €

Piston ring set, for 4 pistons. Suitable for HY Diesel. Peugeot 404 Diesel. Peugeot 504 Diesels, J7

7 Diesel. Engine: XD, XDP, TMD4.88. Bore: 88,0mm. Piston rings: 2,0 + 2.0 + 2.0 + 4,5mm.

• Suitable for this article
• 
  piston ring presenting pliers for diameter 40-100.
  22,71 €
• 
  Piston ring compressor, 60 to 90mm clamping range. Hobby version (not for daily
  16,76 €

Piston ring compressor, 60 to 90mm clamping range. Hobby version (not for daily work).

Degreaser for radiator. For cleaning and degreasing of copper and aluminium radiators. Use: mix 1

kg degreaser in 10 liters warm water. After draining of cooling water fill in radiator with degreasing water: After driving (1-2 days)please drain degreasing water and flush the cooling system with hot water before refilling it. Caution: the cleaning process may uncover some leakages!

• Suitable for this article
• 
  Descaling agent for radiators. For decalcifying of copper and aluminium
  34,61 €

Descaling agent for radiators. For decalcifying of copper and aluminium radiators. Use: mix 1 kg

softening agent in 10 liters warm water. After Draining of cooling water fill in radiator with decalcifying: After driving (1-2 days)please drain softening agent water and flush the cooling system with hot water before refilling it. Caution: the cleaning process may uncover some leakages!

• Suitable for this article
• 
  Degreaser for radiator. For cleaning and degreasing of copper and aluminium
  44,53 €

Radiator Fin Straightener. Designed for straightening fins and removing debris from vehicles

radiators and air conditioning condensers. One tool with 6 different combs works on any vent or grill. The use of this tool allows the radiator or air conditioning grill to work correctly. Also use on air conditioning grills. Also suitable for oil and water radiators/condensers and evaporators

Copper seal type A, (full copper). 16x22x1,5mm.

Clutch Alignment Tool, Universal. For single plate clutches. Suitable for flywheels with or without

pilot bearing. Fast to fit and remove. Universal applications. Size of collets: 14mm to 28mm across 3 adaptors. Cone size range from 35mm < 67mm (for almost all classical french cars)

Clutch line sealing ring (for the line between clutch taker + clutch transmitter). Suitable for

Peugeot 204, 304, 404, 504, 505, J7. Dimension: 6.5 x 10.2 x 7.5 mm. Or. No. 2091.03

• Suitable for this article
• 
  Clutch line screwed joint. Thread: M12x1. Inside diameter: 6,5mm. Suitable for
  2,04 €
• 
  Clutch line support sleeve. Inside diameter: 4,0mm. Suitable for Peugeot 204
  1,14 €
• 
  Plastic line (nylon) between clutch taking cylinder and clutch master cylinder
  7,28 €

Clutch line support sleeve. Inside diameter: 4,0mm. Suitable for Peugeot 204, 304, 404, 504, 505

J7. This sleeve is inserted to the end of the clutch line!

• Suitable for this article
• 
  Clutch line sealing ring (for the line between clutch taker + clutch
  1,18 €
• 
  Clutch line screwed joint. Thread: M12x1. Inside diameter: 6,5mm. Suitable for
  2,04 €
• 
  Plastic line (nylon) between clutch taking cylinder and clutch master cylinder
  7,28 €

Clutch line screwed joint. Thread: M12x1. Inside diameter: 6,5mm. Suitable for Peugeot 204, 304

404, 504, 505, J7. Or. No. 2091.01. Note: There was plastic line with 6,3mm, 7,0mm + 7,3mm diameter. If necessary rebore the screw on that suitable diameter.

• Suitable for this article
• 
  Clutch line sealing ring (for the line between clutch taker + clutch
  1,18 €
• 
  Clutch line support sleeve. Inside diameter: 4,0mm. Suitable for Peugeot 204
  1,14 €
• 
  Plastic line (nylon) between clutch taking cylinder and clutch master cylinder
  7,28 €

Alternator (new part, with integrated alternator regulator)), suitable for Citroen CX 25 2.5TRI

2.5D, 2.5TD, 2.5, 2.5GTI, 2.5GTI Turbo. Peugeot J5 2.5D + 2.5TD. 75A. Or. No. 95493164, 95493165, 95494135, 95494137, 95495989, 95580177, 95598732, 5557.99, 5701.C6, 5705.82, 5705.C3

Alternator Citroen CX 20/22 >79, CX25, CX25D, J5D, 70A, direction of rotation against clockwise

150 Euro old part deposit. Attention, the alternator needs an external alternator regulator!