Rubber bush, for the sheet metal holder of the wiper engine. Suitable for Citroen 11CV + 15CV
Citroen HY. Dimension: 15 x 10,5mm. Or. No. 721187
Citroen HY. Dimension: 15 x 10,5mm. Or. No. 721187
improvement for classic vehicles that use a hand pump without a ball valve to deliver water. This ensures that windscreen washer fluid is always available at the spray nozzles. Please note the direction of flow during installation! It also prevents petrol from flowing back in the fuel line (useful for longer periods of inactivity). Please install this valve close to the petrol pump (between the petrol pump and the tank).
reservoir is supplied with mounting and accessories and can be installed in any vehicle, e.g. Citroen Mehari, Renault R4 first versions, etc. This type of windscreen washer reservoir has also been installed in many Italian vehicles (Alfa Romeo Spider...).
h push-button, cable, cross bars etc. very practical and small. Width 19,5cm, height of 16,5cm, depth 5,5cm
overall height totally: 185mm. Building depth altogether: 100mm. The reservoir is supplied with fixture. The fixture is from the rear at the reservoir.
etc. dimension: 5 x 18 x 4mm.
the original! Mounting diameter: 8,0mm.
screwed with a nut from behind. 2x water jet. Flat design.. Mounting diameter: 8,0mm.
S (DS Installed to year of construction 1969!). M 7x1mm
Citroen DS, to year of construction 1969. In addition, this additional connection is very practical for Citroen DS, HY etc.. Mounting hole: 7,0mm.
connection from above! Made in the European Union. The picture indicates the correct mounting position. The pump section is down, the electric motor above!
well for conversion, e.g. 2CV, Dyane, Peugeot, Renault. Note: The pump is not self-priming. The water must run (from alone) inside. Outlet water = power connection side. If the pump works more than 15 seconds without water, it is broken.
stoppers, 1x T-valve, 3 meters hose. Assembly: Starting from the foot pump with the T-valve, 1x to the reservoir (place the valve in such a way that the water from the reservoir can pass through) and 1x to the windshield washer nozzle (valve lets the water pass in the direction of the nozzle). The flow directions are marked with an arrow on the valve. Assembly instruction online in the shop.
addition, the pump is a reproduction of the first version, and can installed into a Citroen 2CV6 and partial in a Renault R4 .
dashboard. The pump corresponds to the original hand pump as it was mounted in the 2CV6 until the year of construction 1990. Or. No. AZ864-209A. This pump was also installed in the Citroen ID19 until the year of construction 1962 (DM564-9) and the Citroen HY. Please note: The pump has 3 connections: 1x inlet and 2x outlet. For the 2CV with the enclosed T-connector, please bridge 1x (see photo 2 in the shop).
mounting! Suitable for Citroen 2CV. In addition, the pump can be universal installed.
g pressure maximum 7.5 bar. By meters. Custom cut, return not possible!
g pressure maximum 6,0 bar. By meters. Custom cut, return not possible!
pressure maximaum 7.0 bar. By meters. Custom cut, return not possible!
Reproduction. Per piece.
4, Rodeo. Peugeot 403 + 404. 280mm lengthens. Original manufacturer Valeo! For 8mm of wide wiper arms.
Acadyane, HY. Per piece. The wiper blade has a length of 265mm.
6,5mm wide wiper arms with straight connection. Universal suitable. E.g. Citroen DS, AMI, CX, GS. Renault 5,6,12,15,16,17,18. Alpine A110 + 310. Peugeot 204,304,504 and many many other classics.