clutch for Citroën 2CV Alle

Clutch release yoke axle (in the transmission bell housing), suitable for Citroen 2CV6. Length

125mm.

Clutch release lever spring. (Clutch). Reproduction. Suitable for CITROEN 2CV6, starting from year

of construction 1981. Or.Nr.: AM314-9.

Clutch release yoke for the clutch. Old version (first 602cc version), suitable for Citroen 2CV

Dyane, AMI. Or.Nr.: AM314.4

Release fork for the clutch. Suitable for Citroen 2CV6, AK, Dyane, last version, from year of

construction 03/1982. The last improved version of the release fork is reinforced compared to the previous version. Of course, our release forks are made of high-quality steel.

• Suitable for this article
• 
  Clutch release lever plastic sleeve, for the bearing in the clutch housing
  2,33 €

Clutch release lever plastic sleeve, for the bearing in the clutch housing. Suitable for Citroen

2CV4 + 2CV6.

Clutch release sleeve 2CV old, AMI6, old version (thrust ring running in ball bearings), for use of

a multi-disk! Also suitable for Renault R4, to year of construction 1970. Renault Dauphine, 4CV. Or.Nr.: AZ 314.01.

Clutch release sleeve 2CV alt/AMI6, old version (graphitic bearing), for use of the original clutch

with 3 levers. The graphitic ring has 49mm outside diameter, 32mm inside diameter. Totally overall height of 20mm. Also suitable for Renault R4 until 1970, Dauphine, 4CV. Or. No.: AZ 314.01 / Made of very high-quality special graphite with a density of 1.9g/cm3

Clutch release sleeve 2CV6 + 2CV4, Installed of year of construction 1970 to 1982. Reproduction.

Clutch release sleeve 2CV6, Installed starting from year of construction 02/1982. Reproduction

Made in Europe

Clutch release sleeve for Citroen 2CV6, starting from year of construction 02/1982. Original Valeo.

Clutch release sleeve locking spring, for Citroen 2CV6 starting from year of construction 02/1982.

Release ring clutch, for all Citroen 2CV + AMi + Dyane, which have the clutch release yoke above in

the transmission bell housing. (2CV with 9, 12 + 16 HP) of Or.Nr.: A31414

Centrifugal clutch bearing for 2CV6+4, measurement: 17x40x12mm, Inside diameter: 17mm, outside

diameter: 40mm, overall height: 12mm. Or.Nr.: ZC9620103

Centrifugal clutch, check disk for Citroen 2CV. 2,8mm (17x22mm). Or.Nr. AZ33299A

Centrifugal clutch, check disk for Citroen 2CV. 3,3mm (17x22mm). Or.Nr. AZ33299D / AZL6

Centrifugal clutch, nut for the bearing. Reproduction. Suitable for Citroen 2CV. Measurement

16x150mm. Or.Nr. A332 5, AZL6

Centrifugal clutch, retaining ring. Diameter 42mm, 1,4mm heavily. Suitable for Citroen 2CV. Or.Nr

AZ312-87

Centrifugal clutch ring with friction linings. Lining-wide 17,5mm. Suitable for Citroen 2CV with

centrifugal clutch.

Centrifugal clutch ring with friction linings. Lining-wide 26mm. Suitable for Citroen 2CV6 with

centrifugal clutch. Or.Nr.: AM312-7, AZL6

Master brake cylinder, brake system DOT. Single circuit brake system. Suitable for Citroen 2CV

with being pedals. Piston diameter: 22mm. Brake line connector: 1x M12x1 + 1x M10x1mm. Connection brake fluid reservoir: M16. Very rare export version! This master brake cylinder was used also as clutch master cylinder at 2CV Sahara!

• Suitable for this article
• 
  Brake hose copper sealing ring. Dimension: 12 x 18 x 1,5mm.
  0,51 €
• 
  Brake hose copper sealing ring. Dimension: 10 x 16 x 1mm.
  0,51 €
• 
  Master brake cylinder collar outside (seal to the push rod). Suitable for
  3,92 €
• 
  Copper seal type A, (full copper). 16x22x1,5mm.
  0,48 €

Clutch set for 2CV old, from 1952 to 1955, clutch disk with 8 splines. Reproduction, normal gear

shift. 160mm diameter.

Clutch set for 2CV old, from 1955 to 1966, clutch disk with 10 splines, centrifugal clutch

reproduction. 160mm diameter. Note: The clutch must be adjusted after Citroen work instruction!

Clutch set for 2CV old, from 1955 to 1966, clutch disk with 10 splines. Normal gear shift

Reproduction. 160mm diameter. Made in EU

Clutch set for Citroen 2CV6 + 2CV4, of year of construction 1970 to 1982. (For vehicles with drum

brake in front). Dyane of year of construction 1968 to 1982. Mehari from 1968 to 1982. The clutch set consists of: Pressure plate (3 levers) clutch disk and clutch release sleeve. Reproduction, made in Europe. Note: The clutch must be adjusted after Citroen work instruction A.312-00! Made in Europe

• Suitable for this article
• 
  Clutch cable for Citroen 2CV6, Acadyane, Mehari. Installed one until 1990
  11,81 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,93 €
• 
  Flywheel / crankshaft, bearing in the flywheel. Mounting (guide) for the
  9,82 €
• 
  Shaft seal crankshaft rear for 2CV6. Measurements: 56x69x10mm. Original
  12,84 €
• 
  M6x12 screw. Securement clutch pressure plate (3 finger clutch) on the fly
  0,37 €

Clutch set for Citroen 2CV6+4, of year of construction 1970 to 1982. Change of three fingers

pressure plate on multi-disk. Completely with clutch release sleeve. (Pressure on the pedal is lower)

• Suitable for this article
• 
  Clutch cable for Citroen 2CV6, Acadyane, Mehari. Installed one until 1990
  11,81 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,93 €
• 
  M6x12 screw. Securement clutch pressure plate (3 finger clutch) on the fly
  0,37 €

Clutch set for Citroen 2CV6, starting from 02/1982, with torsion bars. The new clutch disk with

torsion bars prevents starting acceleration bucking by e.g. light axial runout of the fly wheel or pressure plate. 160mm diameter, 18 teeth.

• Suitable for this article
• 
  Clutch cable for Citroen 2CV6, Acadyane, Mehari. Installed one until 1990
  11,81 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,93 €
• 
  Flywheel / crankshaft, bearing in the flywheel. Mounting (guide) for the
  9,82 €
• 
  Shaft seal crankshaft rear for 2CV6. Measurements: 56x69x10mm. Original
  12,84 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,46 €
• 
  M7x16 screw + spring washer. Clutch pressure plate (disks clutch) on the fly
  0,68 €
• 
  Fly wheel, new part. Suitable for Citroen 2CV 6, starting from year of
  187,43 €

Clutch completely, for Citroen 2CV6, of year of construction 03/1982 to 1990 (disc brake in front)

Dyane 6, starting from year of construction 1982. Mehari, of year of construction 4/1982 to 1990. Manufacturer: Valeo. 18 teeth, diameters: 160mm. (Multi-disk) new part.

• Suitable for this article
• 
  Clutch cable for Citroen 2CV6, Acadyane, Mehari. Installed one until 1990
  11,81 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,93 €
• 
  Shaft seal crankshaft rear for 2CV6. Measurements: 56x69x10mm. Original
  12,84 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,46 €
• 
  M7x16 screw + spring washer. Clutch pressure plate (disks clutch) on the fly
  0,68 €
• 
  Fly wheel, new part. Suitable for Citroen 2CV 6, starting from year of
  187,43 €

Clutch set for Citroen 2CV6, starting from year of construction 03/1982. Reproduction, Made one in

European Union. 18 teeth, diameters: 160mm. (Multi-disk) new part.

• Suitable for this article
• 
  Clutch cable for Citroen 2CV6, Acadyane, Mehari. Installed one until 1990
  11,81 €
• 
  Fly wheel, shaft seal for the gearbox main shaft (primary shaft) in the fly
  2,93 €
• 
  M7x16 screw + spring washer. Clutch pressure plate (disks clutch) on the fly
  0,68 €

Clutch disk centrifugal clutch. Suitable for Citroen 2CV starting from year of construction

04/1966. 160mm diameter. 18 teeth. Or.Nr.AZ313-01C

Clutch disk for 2CV, from year of construction 1952 to 1955. 8 teeth.

Clutch disk for 2CV, of year of construction 1952 to 1963. 10 teeth, inside diameters: 20/17mm.

Clutch disk for 2CV, of year of construction 1955 to 1966. 10 teeth. Diameter: 160mm. Suitable for

centrifugal clutch.

Clutch disk starting from 02/1982. Suitable for Citroen 2CV6.

Clutch disk, starting from year of construction 03/1982. Suitable for Citroen 2CV6. Diameter

160mm. Number of teeth: 18. Hub profile: 17,8x20,3-18N. Manufacturer: Sachs!

Clutch disk, to year of construction 02/1982. Suitable for Citroen 2CV6. Diameter: 160mm. Number of

teeth: 18. Hub profile: 17,8x20,3-18N. Manufacturer: Sachs!

Centring (from synthetic) for the clutch. Suitable for Citroen 2CV

Clutch Alignment Tool, Universal. For single plate clutches. Suitable for flywheels with or without

pilot bearing. Fast to fit and remove. Universal applications. Size of collets: 14mm to 28mm across 3 adaptors. Cone size range from 35mm < 67mm (for almost all classical french cars)

M6x12 screw. Securement clutch pressure plate (3 finger clutch) on the fly wheel. Suitable for

Citroen 2CV6 + 2CV4, to year of construction 1981.

M7x16 screw + spring washer. Clutch pressure plate (disks clutch) on the fly wheel. Suitable for

r Citroen 2CV6, starting from year of construction 1981.