Ducellier, ignition contact (D338). Suitable for Citroen Ami8 SUPER, of year of construction
04/1972 to 09/1977. Citroen GS, starting from year of construction 09/1978. Visa SUPER (engine XW3), of year of construction 09/1978 to 12/1980.
04/1972 to 09/1977. Citroen GS, starting from year of construction 09/1978. Visa SUPER (engine XW3), of year of construction 09/1978 to 12/1980.
is a reproduction. It is not of the same high quality (both in terms of workmanship and the components used) as our 14300 ignition system, but this reproduction ignition system is still interesting for those who don't drive much. Because it is much better than the normal contact and condenser controlled ignition! It's your decision! However, we ourselves continue to ride with the 14300 ignition system, which has never let us down for over 18 years!
rs many different advance curves, 5 for tuning with regular fuel, 5 for tuning with LPG/ethanol and 5 'standard'-curves as prescribed by Citroen for ALL two cyl.-engines, inclusive VISA-engines. The 123\EVO also offers : vacuum-advance, warm-up-advance, overheat-retard, spark-balancing, dwell-balancing, current-time-out, idle-speed-control.
to install and no longer has any mechanical components that can wear out. There is no need for any maintenance work on the ignition. You will be thrilled! We have already sold more than 10000 systems. And if you want your 2CV to run even better, we recommend our ignition coil 14395. The ignition system is designed for original engines. (A79/1, M28, M28/1 engines).
hign-performance ignition coil "made by Franzose" is the solution to the well known problem of defective 2 cv ignition coil. No more bucking! No need anymore to have on bord an ignition coil for replacement! This high-performance ignition coil works in combination with electronic ignition (14300) as well as with ignition contacts warranting in both cases a reliable operating. A further advantage of this high-performance ignition coil is a much better start. This high-performance ignition coil has by 10 volts the same output as the normal ignition coil by 14 volts- This enables a much better start. When starting vehicle electrical system voltage decreases till approx.9-10 volts. At this level the high-performance ignition coil is already highly efficient. Because there is no high-resistance oil anymore between the primary wave and the secondary wave and thanks to safe plastic used this high-performance ignition coil has a long life expectancy. Content: mounting bracket, 2x ignition cable, 2x NGK ignition plug. CAUTION:our ignition coil is only compatible with our electronic ignition systems (items n°14300 + 14325). Other electronic ignition systems work with a different resistance what can destroy the ignition coil!
appropriate advance-curve can be selected with a 16 position rotary-switch, behind an opening in the front of the housing. The unit will work on 6 Volt and on 12 Volt systems. The '123\UNI' is designed to work on '2CV' 9 hp, 375cc, A53, M4, A79/0, M28, A79/1 and M28/1 engines in conjunction with the stock black coil. (6 Volt type for 6 Volt battery, and 12 Volt type for 12 Volt battery) The dwell is automatically adjusted. Upon installation, the user has to check his engine plate ( "A", "AZ", "AM", "AYA", "AM2", "AYA2", "AK2", "A06/635", "A06/642", "AM2A" or "A06/664" ) and look in the manual which setting of the rotary-switch is appropriate. There also is a special setting for M28/1-engines running on LPG or on Ethanol, like 'E85' as used in Sweden. ( 'E85' contains 85 percent ethanol, and 15 percent standard fuel )
gasket, 1x air cleaner element, 1x set of ignition cables silicone, 1x condenser, 1x ignition contact, 2x spark plug.
bent into the correct position. We apologize, but other 6-volt condensers are no longer available. An alternative is to convert to a 6-volt electronic ignition system (our item number 14328) or push the car.
manufacturer Valeo/BERU/ANGLI.
connection, Installed until 1968. Made in France.
(Closure of the engine fan housing). Original equipment quality. The best cables for 2CV! Made in Spain. This cable has a high ohmic resistance. Suitable for our spark plug 14301.
high ohmic resistance. Suitable for our spark plug 14301.
Made in Spain. This cable has a very low ohmic resistance. Suitable for our spark plug 14394. Basic information about interference suppression: Up to the year of construction 1979, the ignition cables had a low resistance. The same applied to the spark plug. Suppression chokes were installed for the suppression. Today, this can be done immediately by combining high-resistance spark plugs with low-resistance ignition cables.
non-interference suppressed spark plug (low ohmic resistance). For interference suppression (radio) you need ignition cables with high ohmic resistance.
spark plug (high ohmic resistance). Basic information on interference suppression: Up to the year of construction 1979, the ignition cables had a low resistance. As did the spark plug. Suppression chokes were installed for electrical interference suppression. This can be avoided today by combining high-resistance spark plugs with low-resistance ignition cables.
of the spark plug can be checked very easily and safely. So, if the engine does not start: Is the spark plug sparking at all! And if so, how strong! Then exclusion procedure: Ignition OK? It is not getting any petrol!
where they are deep seated or require off-line access. The tool is also designed to grip the spark plug securely allowing the removal with ease.
installation spindle. 10x heli coil insert M14x1,25x17,5. (Spark plugs with long threads). 10x heli coil insert M14x1,25x12,7. (Spark plugs with short threads, 2CV, R4).
after production from Europe.
Citroen DS. It can be used with the normal electrode extension. Fitting for 3/8 inch ratchet (medium size). Fits of course also on all other spark plugs, for 21mm tools. Manufacturer: HAZET. Adjustable length from: 137,5mm to 157,5mm and 195,5mm. With spark plug holding rubber.
Peugeot 203, 403, 404, 504. Workshop quality!
epoxy (plastic) filling as resistor instead of an oil filling (as resistor between the primary and secondary coil). Some swear by it (and sell it as a performance ignition coil), others prefer the original ignition coil (our 14307, was installed 7 million times in new 2CVs) or our 14395 (this is a real high-performance ignition coil). We ourselves drive all our 2CV's with the 14395 coil!
ignition coil is often to blame!
Installed, which has still 6 V technology. (in the DS are 2 ignition coils installed!)