for Citroën HY
1686 Articles | Page 12 of 34
Rubber seal profile (by meters), for nearly all older Citroen, 2CV, HY, DS. (Door + luggage
compartment seals)! Made in Germany! Quality: EPDM 317. Easily rubbed in with talcum powder. Wide one: 25,5mm
Rubber seal profile, more curved. We let produce this profile rubber in Germany. The rubber is more
curved in itself and can seal so better (e.g. bonnet, rear flap). Suitable for Citroen HY. By meters. Wide one: about 29,5mm. Note: Do not unse this rubber for the doors!
Rubber cap for the connection to the starter motor. (Protecting cap). This cap should never be
missing. Universal fitting! For max. cable diameters: 17,8mm. Inside diameter 22mm.
Rubber cap for the connection at the generator. (Protecting cap). This cap should never be missing
Universal fitting! For max. cable diameters: 7,62mm. Inside diameter 12,7mm.
Rubber knob for the heater flow control valve, in the interior (engine tunnel). Suitable for
Citroen DS Non Pallas, up to year of construction 1968. Citroen HY for the heating. Or. No. ZC9804104U
Rubber ring with hook, for the upholstery of the seats. 50 pieces! Very good quality from the
original manufacturer. These rubber rings are slightly more elastic, softer, than the replica rubber rings (18026). Suitable for Citroen 2CV, Dyane, HY. Or. No. A922114.
Rubber ring with hook, for upholstering the seats. Per piece. Replica. Suitable for Citroen 2CV
Dyane, HY. The replica rubber rings are somewhat tighter, harder, than the original rubber 18442. Or. No. A922114. In the 2CV seat there are 22 rubbers in the lower seat and 26 rubbers in the backrest. There are approx. 100 rubbers in a seat bench.
Rubber cylinder, for the seat adjustment. Suitable for Citroen 11CV/15CV, Citroen HY. Dimension: 22
x 27,5mm. Or. No. 233163
Rubber rosette (seal) under the door handle + luggage compartment handle. Suitable for Citroen
11CV, 15CV + Citroen HY. Dimension: 60 x 35 x 5mm
Rubber rosette under the luggage compartment handle. Suitable for Citroen 11CV + 15CV, to year of
construction 07/1952. Citroen HY. Diameter: 46mm. High: 4mm. Or. No. 224192R
Hook set, 135 mm long. 4 pieces, ideal for removing O-rings, seals, Citroën brake line seals, etc
Contents: 1x straight tip, 1x 90° tip, 1x hook tip, 1x piercing tool.
Retaining clip emblems for Citroen, Renault, Peugeot, old models. 2.5mm inner diameter (i.e. for
2.5mm pins on the emblems). Length: 7.5mm. Per piece
Retaining clip for the seal from the luggage compartment lid. Suitable for Citroen 11CV/15CV
Citroen DS. Dimension: 10 x 14mm. Also suitable for other French vehicles. Or. No. 802698, DM453-120C
Hand brake cable on the left. Suitable for Citroen HY, to year of construction 1962. Length
2090,0mm. Or. No. H4541B
Hand brake cable on the right. Suitable for Citroen HY, to year of construction 1962. Length
2280,0mm. The hand brake cable has a lubrication nipple! Or. No. H4541C
Hand brake cable, on the left + on the right fitting. Suitable for Citroen HY, starting from year
of construction 1963. Or. No. 5490010
Hand brake cable, on the left + on the right fitting. Suitable for Citroen HY, to year of
construction 1962. Length: 1210,0mm. Socket length: 920,0mm. Or. No. HY4541A
Master brake cylinder repair set (only seals), dual circuit brake system. Suitable for Citroen HY
starting from year of construction 1976. Made in France
Master brake cylinder dual circuit brake system. Suitable for Citroen HY, starting from year of
construction 1976. Piston diameter: 25,4mm. Made in France
Master brake cylinder, 1 inch (25,4mm) piston. Suitable for Citroen 11CV + 15CV. Citroen HY
Renault Fregate, Juva 4. Simca Vedette, Regence, Versailles to year of construction 7/1955. Made in Europe.
Main cable harness, without tail cable harness. Suitable for Citroen HY, from year of construction
09/1964 to 1970 (round switches in the dashboard). Made in Germany.
Main cable harness, without tail cable harness. Suitable for Citroen HY, from year of construction
1947 to 09/1964. Made in Germany.
Main cable harness, without tail cable harness. Suitable for Citroen HY, from year of construction
1970 to 1981 (square switches in the dashboard). Made in Germany.
PDF FILE Rear end panel cross-beam completely. Suitable for Citroen HY to year of construction 1963. The
cross-beam is supplied inclusive the bumper bows.
Rear end panel cross-beam completely. Suitable for Citroen HY, with rear bumper (not suitrable for
HY with pipe bow). Or. No. HY744-67
Tail sheet metal on the left + on the right for increase of the roof (175mm highly). This sheet
metals are welded on the original tail sheet metal! (1 pair)
Tail sheet metal on the left down (without cross-beam on the rear side). Suitable for Citroen HY
to year of construction 07/1961. Or. No. HP823-2A
Tail sheet metal on the left, only outer sheet metal. Complete height for a normal Citroen HY
Installed starting from 9/1963.
Tail sheet metal on the left. Mounting for the tail lamps. Suitable for Citroen HY. It is the
external sheet metal, with cross-beams. Length about 600mm.
Tail sheet metal on the left. Mounting for the tail lamps. Suitable for Citroen HY. It is only the
external sheet metal, without cross-beams. Length about 1000mm.
Tail sheet metal on the left. Suitable for Citroen HY Pick UP, starting from year of construction
1963. The tail sheet metal fits for the original AXO lights and has a projection for the license plate light.
Tail sheet metal on the left. Suitable for Citroen HY Pick UP, starting from year of construction
1963. The tail sheet metal fits for the original AXO lights!
Tail sheet metal on the left. Suitable for Citroen HY Pick UP, starting from year of construction
1963. The tail sheet metal is without hatches for tail lamps, but with projection for a license plate light.
Tail sheet metal on the left. Suitable for Citroen HY Pick UP, starting from year of construction
1963. The tail sheet metal is without lamp bores for tail lamps.
1686 Articles | Page 12 of 34
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
