2CV, brass bushings in pedal floor for standing brake pedal + clutch pedal (guide for the pedals in
the floor panel). Suitable for Citroen 2CV, AZU up to approx. year of construction 1970.
pedal gear for Alle Alle
68 Articles | Page 1 of 2
Brake actuator (in pedal bracket) for "champion" brake button (only the slider). Suitable for
Citroen DS, hydraulic system LHM. The slider is mounted in the pedal block. Or. No. DXN453-021 (1D 5410496P). In exchange. Plus 150 Euro old part deposit.
Brake operation (hydraulic brake control) for mushroom brake button. Suitable for Citroen DS
Hydraulic system LHM. The complete block is supplied. It was reconditioned with new, calibrated pistons. The pedal adjustment for the rear wheel brake, was adjusted after factory regulations. Inclusive 12 ring seals for the bank of tubes. Plus 250 Euro Old part deposit.
Brake light switch old version. Suitable for Citroen 2CV (6 volt), AMI6 + Citroen ID19, up to year
of construction 08/1961 (DM576-02, does not fit Citroen DS). The brake light switch is mounted in the engine compartment on the firewall. Reproduction. Or. No. AZ57602 (2CV). However, with a little skill, the brake light switch can also be converted to fit the DS19 with Or. No. DS576-02A. The brake light switch for DS19 is no longer available.
Stop light switch at the brake pedal. Connection flat plug. Connector: M12x1. Suitable for Citroen
2CV6, DS, CX, BX, HY, GS
Brake light switch on the pedals, suitable for Citroen DS (type DV + DT), up to year of
construction 09/1970 (except Pallas). Citroen ID 19 from year of construction 09/1961 Or. No. DM576-02A
Stop light switch, 2 pole. Thread: M10 x 1. Suitable for Renault R4, R5, R16. Citroen AX, BX, CX
starting from year of construction 1981. Peugeot 205, 504, 505. Talbot Samba.
Stop light switch, mounts at the master brake cylinder. Thread: 7/16 x 20UNF. Suitable for Renault
R4, of year of construction 1961 to 1970. Renault Estafette, R8, R10. Peugeot 204, of year of construction 1966 to 1969. Simca 1000.
Stop light switch. Suitable for Citroen HY, to year of construction 01/1973. Original one, no
reproduction (NOS). Or. No. HG576-02
Roof frame, rubber buffer on the side of the roof frame (roof frame 37838 + 37839). The bumper is
mounted in the reinforcements for the screw connection. Suitable for Citroen DS. This rubber is also mounted in the accelerator pedal as a stop.
Spring for brake pedal + clutch pedal. Suitable for Citroen HY, Installed starting from year of
construction 12/1969. Diameter: about 20mm. Length: about 155mm. 41 turns. Or. No. HY435-25. Note: With Citroen HY, from year of construction 12/1967 to 12/1969, is installed 1x spring article no. 48240 (ZC9089071u clutch) + 1x article no. 48292 (HY435-25 brake).
Spring for brake pedal + clutch pedal. Suitable for Citroen HY, Installed up to year of
construction 12/1967. Diameter: about 12mm. Length: about 220mm. 31 turns. Or.Nr. ZC9089071U. Note: With Citroen HY, from year of construction 12/1967 to 12/1969 is 1x the spring article no. 48293 (ZC9089071u clutch) + 1x article no. 48292 (HY435-25 brake) Installed.
Foot throttle stop rubber, for Citroen 2CV. The rubber is mounted above in the foot throttle, for
vehicles with being foot throttle. (the foot throttle is mounted on the pedal floor plate)
Foot throttle being for Citroen 2CV, mounts on the pedal floor plate. The foot throttle is tapered
above. Installed in a 2CV starting from 03/1966.
Foot throttle being for Citroen 2CV, mounts on the pedal floor plate. Suitable for Citroen 2CV, to
year of construction 03/1966.
Foot throttle fixture down, for Citroen 2CV. For Citroen 2CV with being foot throttle. (Foot
throttle is mounted on the pedal floor). The fixture must be adapted! There is unfortunately no good foot throttle fixtures more supplyable!
Foot throttle mounting board (fixture) down. For Citroen 2CV with being foot throttle. (Foot
throttle is mounted on the pedal base.) Made in Europe.
Master brake cylinder push rod (adjustable). Length: 88mm. Mounted between brake pedal and master
brake cylinder. Suitable for Citroen 2CV with hanging pedals.
Pedal rubber chrome frame for the accelerator pedal. Suitable for Renault R16 TS + TX. Renault R12
R17. 43 x 140 mm, Or. No. 7700569873
Pedal rubber for chrome frame. Suitable for Renault R4, R16 TS/TX, R15, R17, and many other Renault
(can be re-tooled). Or. No. 7700569868 + 770569870
Pedal rubber for the parking brake. Suitable for Citroen DS Pallas. The pedal rubber is napped
External dimensions: ca.73x49. Good reproduction. Without metal frames! Or. No. 5420552U
68 Articles | Page 1 of 2
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
