Search for 202
You are currently searching without specifying a vehicle / model.
To give you a better search experience, we recommend that you select your vehicle.
Select vehicle now No thanks
47 Articles
P 202/203/403/404, wheel brake cylinder rear. Piston diameter: 25,4mm (1 inch). Suitable for
Peugeot 202, 202, 403, 404. Simca Aronde + Renault Fregate. Brake line connector: 7/16x20 UNF (funnel port = F flange). Mounting board bore: 36mm. Length over everything: 67mm. Or. No. 4402.08 + 4402.09. Made in Spain.
Gasoline filter, round. Suitable for Citroen DS IE (injection engine). Outside diameter: 55mm
Length: 139mm. Gasoline line of connections: 8mm. Or. No. DX173202A
Axle on the anchor plate, for the mounting from the lower eccentrics of the brake liners. Suitable
for Citroen 2CV. Or.Nr.: AZ 451 202A
Brake fluid reservoir with locking cap, for the brake system DOT. Suitable for Citroen 2CV to year
of construction 1963. Peugeot 202, 203, 403, 404. Renault rear engine, R4. Diameter: 57mm. Reservoir height with locking cap: 97mm. Threaded connection on the master brake cylinder: 3/4 16h. Made in Spain.
Brake caliper (1 piston) at the rear left, with integrated parking brake. Brake system Bendix
Piston diameter: 30mm. This brake caliper is installed at many Peugeot 205, Renault R5 Super. Or. No. 440161, 441007, 440161, 7701202142
Brake caliper (1 piston) at the rear right, with integrated parking brake. Brake system Bendix
Piston diameter: 30mm. This brake caliper is installed at many Peugeot 205, Renault R5 Super. Or. No. 440162, 441008, 440162, 7701202143
Differential double ball bearing (bearing, for the connection of the drive shaft). Suitable for
Citroen DS. Dimension: 30 x 72 x 23,8mm. Or. No. ZC9620267U
Dyane, seat bench box completely, for Citroen Dyane. Or.Nr. AY831-202A Measurements of the box
135x28x17cm. Made in Europe.
Electronic ignition system. Suitable for Citroen SM. The ignition system has been completely
redeveloped in 2021, and contains a completely new software in addition to the proven hardware. It is therefore completely compatible with the odd ignition sequence of the Citroen SM. The ignition distributor has received a ball bearing to reduce heat production and have an even more accurate guidance. Other special features: Signal output that imitates the signal of a dual ignition coil. So there is no need to modify the original r.p.m counter. Also the D-Jetronic injection is supported. The ignition system is supplied including a new high performance ignition coil. Finally a perfect solution for the Citroen SM.
Gearbox bearing lower (jackshaft). Suitable for Citroen HY, starting from year of construction
09/1966. Dimension: 30 x 72.0 x 78.5 x 30,2mm. Or. No. ZC9620286U + 620010
Rear rack from aluminum. Dimension: 870 x 370 x 100mm. Drilling measurement: 490 x 445mm. For the
securement you require: 4x screw M6x20 (20173), 4x washer M6 (20270) + 4x rubber washer (15493).
Rear rack from polished high-grade steel, with wooden strips. Dimension: 890 x 470mm. Drilling
measurement: 490 x 445mm. For the securement you require: 4x screw M6x20 (20173), 4x washer M6 (20270) + 4x rubber washer (15493).
Rear rack from polished high-grade steel. Dimension: 870 x 370 x 100mm. Drilling measurement: 490 x
445mm. For the securement you require: 4x screw M6x20 (20173), 4x washer M6 (20270) + 4x rubber washer (15493).
Rocker arm exhaust, suitable for Citroen DS, from year 1965. Citroen HY with aluminum cylinder
head. Total length approx. 107mm. Or. No. 1D5412021R + D124-2A
Steering wheel foamed, completely with steering column. In the exchange. Suitable for Citroen DS
final version. Or. No. DX441202A. Plus 250 Euro Old part deposit.
Oil drain screw magnetically, suitable for Citroen 2CV, HY, DS, 11CV (with oil pan out of sheet
metal). Interior square. The suitable tool has our number 20221. Or. No. A1321M, thread M16x1,5x20
Master brake cylinder Peugeot 202, Peugeot 203, Peugeot 403. Installed to year of construction
10/1960. Piston 25,4mm. (1 inch). Reproduction
P 203/202, engine suspension. Suitable for Peugeot 203 + 202 (on the left of or on the right
suitable). Securement hole center to hole center: 65mm. Or. No. 1807.06
P 203/403, water pump for Peugeot 203 + 403 (D3A D4A, D4B). The fan is uncouplable. Axle belt
pulley 15mm, the bearing comes from SKF. Or. No. 120243. Caution: The P 203 has an open cooling system. It is essential to check if the radiator cap is the right one ! The water pump can evacuate some cooling water through a small opening. New water pumps need approx. 500 km to 1000 km to get at 99,5 % leakproof. It is just normal to see some drops of water on the water pump!
P 204/304, water pump, with disengageable fan blade. Length of the axle: 54,5mm to water pump
housings. 60mm up to the bearing. Suitable for Peugeot 204 + 304. For engine: XK5/4, XK, XL, XIDL. Or. No. 1202.67
P 204/304/404/202, front brake hose. Fits Peugeot 204 + 304, from probably 1966 to 1969. Length
376mm. Thread inside: 3/8 x 24 UNF (both sides). Thread outside: 5/8 x 18 UNF (both sides). Attention: These brake hoses are for brake line flare bolts through thread! Up to approx. year of manufacture 1966 the flare screws have a thread offet at the bottom! Made in Europe.
P 204/404/202, brake hose front, suitable for Peugeot 204 + 404, up to presumably year of
construction 1966. Peugeot 202 rear. Length: 376mm. Thread inside: 3/8 x 24 UNF (both sides). Thread outside: 5/8 x 18 UNF (both sides). Attention: These brake hoses are for brake line flare bolts with thread offset at the bottom! From approx. year of manufacture 1966 the flare screws have been replaced by a full thread! Made in Europe.
P 404, windshield seal (for mounting with sealing trim). Suitable for Peugeot 404 sedan + BREAK, of
year of construction 1959 to 1979. Reproduction of brand manufacturers from France. Or. No. 812025
P 404/504, water pump, disengageable fan. Suitable for Peugeot 404 + Peugeot 504. For 1,6, 1.8
2,0L engines (XM/XM7). The water pump is for the second version, with disengageable fan blade. Length of the shaft: 55mm. 4x connection. Or. No. 1201.79 + 1202.70 + 1202.71 + 1202.61
P 404/504, water pump, for disengageable fan blade. Suitable for Peugeot 404 + Peugeot 504. Engine
For 1,6, 1.8, 2,0L (XC7). Installed starting from year of construction 1960. The water pump is for the first version, with disengageable fan blade. Length of the shaft: 53mm. 3x connection (1x plugged). Or. No. 1202.60, 1202.12, 1202.36, 1202.48, 1202.59, 1202.84
P 404/504, water pump, for rigid fan blade. Suitable for Peugeot 404 + Peugeot 504. Engine: For
1,6, 1.8, 2,0L (XC7). Installed starting from year of construction 1960. The water pump is for the first version, with rigid fan blade. Length of the shaft: 37mm. 3x connection. Or. No. 1202.13 + 1202.37
P 404/504, water pump, rigid fan. Suitable for Peugeot 404 + Peugeot 504. For 1,6, 1.8, 2,0L
engines (XM/XM7). The water pump is for the second version, with rigid fan blade. Length of the shaft: 37mm. 4x connection. Or. No. 1201.78 + 1202.69 + 1202.83 + 1202.72 + 1202.76
P 404/HY, water pump. Suitable for Peugeot 404 Diesel. Citroen HY Diesel. Engine XD88. Installed
from year of construction 1960 to 1975. Or. No. 1202.44 + 1202.90
P 504, water pump. Suitable for Peugeot of 504 Diesel. 1,9D + 2,1D. Installed from year of
construction 1978 to 1982. Engine: XD88, XD90. Or. No. 1202.73 + 1202.74 + 1202.85 + 1202.86
P 504/505, water pump, with disengageable fan. Length of the shaft: 55mm. Suitable for Peugeot 504
Peugeot 505. For 1,8 + 2.0 engines. (XM). Starting from serial number: CH3061637. Or. No. 1201.31 + 1201.89 + 1202.82 + 1202.97
P 504/505, water pump. Suitable for Peugeot 504 (1,8L + 2,0L), Peugeot 505 (1,8L + 2,0L). Engine
code: XM. Rigid fan blade. Length of the shaft: 40mm. Installed starting from year of construction 8/1979. Or. No. 1202.98 + 1201.90
R4 GTL, Water pump Renault R4 GTL (1108ccm), R112. From year of construction 06/1986 to 06/1990
Without pulley, incl. gasket. Original from Valeo! No reproduction. Or. No. 7701455720, 7701455972, 7701512202, 7702039671
SEV, distribution arm SEV 466. Suitable for Citroen 11CV, starting from year of construction 1942
Citroen HY. Peugeot 202, Peugeot 203 starting from year of construction 1949. Peugeot 403, starting from year of construction 1955. Peugeot 404, starting from year of construction 1960. Renault R4, Fregate, Juva, Dauphine, Floride. Simca 8, Aronde, Ariane. Suitable distributor cap: 72182
PDF FILE 
SEV, distributor cap SEV 453. Outside diameter: 58,7mm. Suitable for Citroen 11CV, starting from
year of construction 1942. Citroen HY. Peugeot 202, Peugeot 203 starting from year of construction 1949. Peugeot 403, starting from year of construction 1955. Peugeot 404, starting from year of construction 1960. Renault R4, Fregate, Juva, Dauphine, Floride. Simca 8, Aronde, Ariane. Suitable distribution arm: 72183
Brake caliper sealing set. Suitable for Citroen SM, starting from year of construction 11/1972
Consisting of: 2x sealing ring 31,5x37,7x2,8mm (GX2510302A). 2x sealing ring 32x37x2,5mm (GX2510202A). 1x sealing ring 7,2x11x1,9mm (24822009W + ZD9482200U).
Water pump, suitable for Citroen HY Diesel. Peugeot 505 Diesel, Peugeot J7 Diesel. Possibly the two
small connections must be plugged. Or. No. 120187, 120295, 120291, 120288, 120299. Hose flange diameter: 1x 16mm, 1x 55mm, 1x 42mm.
R4, Tie rod completely on the left (inclusive tie rod end). Suitable for Renault R4, of year of
construction 1964 to 1968. Or. No. 7701450480 Made in Italy
47 Articles
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
