Wheel brake cylinder in front on the left, above. Suitable for Citroen HY + Citroen 15CV. Piston
diameter: 32,0mm. Brake line connector: M12x1mm. Or. No. 620004.
diameter: 32,0mm. Brake line connector: M12x1mm. Or. No. 620004.
diameter: 32,0mm. Brake line connector: M12x1mm. Or. No. 620004A.
diameter: 32,0mm. Brake line connector: M12x1mm. Or. No. 620004B.
diameter: 32,0mm. Brake line connector: M12x1mm. Or. No. 620004C.
Citroen HY. Or. No. H741-110
wheel! The sheet metal has a "dent". Or. No. H821-93
Citroen HY. Or. No. H741-110A
passenger seat is attached to the wheel arch. Or. no. HY741-71A
passenger seat is attached to the wheel arch. Or. no. HY741-61
if the original caps are no longer beautiful, adorn new hub caps the complete vehicle.
Suitable for Citroen HY. Or. No. H821-93A
fitting! Per piece. Outside diameter: 90,0mm. Inside diameter: 45,0mm. Overall height: 50,0mm
bearing: 90 x 45 x 50mm.
Wheel bearing: 90 x 45 x 50mm.
bearing: 90 x 45 x 50mm.
bearing: 90 x 45 x 50mm.
change. Seals small holes in the tyre and pumps it up. Practical, fast and safe. 400ml
with 15mm hole for valves. New valves are always 13mm in the diameter.
Made one in European Union.
Citroen HY. Dimension: Measurements: 8.9 x 14.3 x 2,7mm. Made in Germany.
a punched-out sheet metal which has been nickel-plated. They are not as sturdy and pretty as our numbers 21143, 21144, 21145, but these rosettes are more like the original rosettes used in early Citroen 2CV, R4, Dauphine etc. Higher-quality vehicles were more likely to have our shiny alternatives (e.g. Citroen DS).
used for dashboard, door linings. Suitable for Citroen 2CV, DS, HY and in many Peugeot + Renault. Our rosettes are shiny and flanged at the back. This makes them very stable.
used for dashboard, door linings. Suitable for Citroen 2CV, DS, HY and in many Peugeot + Renault. Our rosettes are shiny and flanged at the back. This makes them very stable.
e used for dashboard, door linings. Suitable for Citroen 2CV, DS, HY and in many Peugeot + Renault. Our rosettes are shiny and flanged at the back. This makes them very stable.
the cleaned rust spot must then be preserved with paint immediately.
The headlamp is for a later mounting underneath the bumper! It cannot be used as substitute for the original backup lights from R4! Lampholder for the bulb: Ba15s. Maximum 21Watt. (Our number 14035 + 14045).
143mm. Diameter 10mm. Spring length about 70mm. Or.Nr. ZC9438770U
improvement for classic vehicles that use a hand pump without a ball valve to deliver water. This ensures that windscreen washer fluid is always available at the spray nozzles. Please note the direction of flow during installation! It also prevents petrol from flowing back in the fuel line (useful for longer periods of inactivity). Please install this valve close to the petrol pump (between the petrol pump and the tank).