2CV, Window weatherstrip (pane seal) in the C-support. Suitable for Citroen 2CV. Reproduction from
the original supplier! Or.Nr. 95588535
the original supplier! Or.Nr. 95588535
cost starting from 59 Euro.
m. Caution! Increased shipping cost starting from 59 EURO.
Overall length about 2250mm. Made in France
This sealing trim was used also with the side windows in Citroen a AK, AZU, Dyane, HY. Made in France
high-grade steel. Ordered please the connection clip specially!
frame was only mounted on the Belgian 2CV AZAM. Attention: The bonding of the butt edges of the gasket are really bad. But we still offer this rubber, because there are no other rubbers for the AZAM. If you need it, it is better than no rubber!!!
Suitable for Renault 4CV.
the upper and lower rear window rubber). A typical accessory from the fifties. Made in France
the inside! Measurements: 32x250mm.
reproduction. Measurements: 25 x 230mm.
inserted into the upper and lower rear window rubber). A typical accessory from the sixties. Made in France
cover or Hardtop). The seal is always mounted on the cover or at the Hardtop. Nearly all Cataveele/Floride requires this seal (there always defective)! Shape profile with rounded corners! Length about 110cm. Suitable for Renault Caravelle + Floride. Or. No. 5552411
disks. Suitable for Citroen CX sedan + BREAK. You need 8 clips for the triangle window, per side (BREAK = 14). Or. No. 95590851
disks. Suitable for Citroen CX sedan + BREAK. You need 8 clips for the triangle window, per side (BREAK = 14). Or. No. 5432415 + 95590851
into the upper and lower rear window rubber). A typical accessory from the sixties. Made in France
DS961-146B. Consisting of our article number: 35034 + 37714.
the seals must be clogged with one another!
brackets are only inserted into the upper and lower rear window rubber). A typical accessory from the sixties. Made in France
searched for a long time and tried different products. This adhesive, which dries and hardens under UV light, is perfectly suited for fixing interior mirrors(rear-view mirrors) of a DS, window handles for sliding windows (Renault R4) or for the handles of triangular windows (VW T3, Alfa Romeo Spider, etc.). The adhesive is thick (gel-like) and should dry under the UV lamp (you also need 3x AAA batteries), also supplied with. As far as the adhesive has not been dried under the UV lamp, you can still make corrections (or wipe off excess adhesive). Of course, you can also use it to glue the handles of beer mugs or the bases of wine glasses! Technical details: Single-component adhesive that dries under UV light. Based on acrylate and polyurethane. The adhesive dries under UV light in the range of 320-400 nm within 15-20 seconds. The adhesive does not yellow. content of delivery: Acrybond adhesive 16 g. 1x UV lamp 1 W (batteries not included). Made in Germany. Believe us, if this adhesive had been available when we were young, we could have saved ourselves a lot of trouble..
the upper and lower rear window rubber). A typical accessory from the sixties.
inserted only into the upper and lower rear window rubber). A typical accessory from the sixties.
the upper and lower rear window rubber). A typical accessory from the sixties.
possible by forwarding agent according to daily updated prices (very expensive, we will submit an offer to you).
shipping costs, as only possible by forwarding agent according to daily updated prices (very expensive, we will submit an offer to you).
costs, as only possible by forwarding agent according to daily updated prices (very expensive, we will submit an offer to you).
costs, as only possible by forwarding agent according to daily updated prices (very expensive, we will submit an offer to you).