for Citroën 2CV AMI6-8
1739 Articles | Page 34 of 35
Seal under carburetor lightly, seal between distance plate and carburetor. Suitable for Citroen
2CV6 with oval carburetor. Quality after production from Europe.
Seal under carburetor, distance plate between intake manifold and carburetor. Suitable for Citroen
2CV to year of construction 1981, with round carburetor. Inside diameter 34mm. Made in Germany
Carburettor base gasket, spacer plate between intake manifold and carburettor. Suitable for Citroen
2CV6 with oval carburettor. Made in Germany. Thickness: approx. 9.0 mm. This plate, made in Germany, is manufactured in the same way as the original plate, with many layers of sealing paper soaked in resin and pressed together. There are also many carburettor plates made of plastic on the market, but these do not achieve the same level of insulation.
Seal under carburetor, distance plate between intake manifold and carburetor. Suitable for Citroen
2CV6 with oval carburetor. Reproduction. Thickness: about 9mm.
Seal under carburetor, distance plate. Installed in Citroen 2CV with 375 + 425cc with round
carburetor. Inside diameter 28mm. Or.Nr.: AZ142-98
Latching pin, which is inserted from above into the medium seat slide. Suitable for Citroen 2CV. It
prevents, that slips the seat frame from the seat slide. Or. No. 1A 5437 263K
Guide sleeve in the gearbox, for the connection engine + gearboxes. For 2CV. Measurement
10x14x27,5mm. Very good after production from the European Union.
Motor-gearbox screw connection: Short stud bolts (these are the lower stud bolts) between the motor
and gearbox. Suitable for Citroën 2CV6 + 2CV4, Dyanne AMI8, Mehari
Motor-gearbox screw connection: long stud bolts (these are the upper stud bolts, as they also hold
the air filter holder) between the motor and gearbox. Suitable for Citroën 2CV6 + 2CV4, Dyane, AK, Ami8
Front axle cover sheet. (Cover at the steering gear, below the tie rod securement). Suitable for
Citroen 2CV. Or. No.: A44278A
Front axle sliding sheet metal, safety sheet. (Sliding sheet metal on the steering unit). Suitable
for Citroen 2CV. Or.Nr.A44295
Front axle pipe - steering gear in the exchange. Suitable for Citroen 2CV4 + 2CV6. Top outdated
all bearings and pinions are accurately bedded in and measured. The steering worm and the gear rack are re-tooled with grease nipple. To lubricate thus at any time from the outside. 250 euros Old part deposit.
Hazard warning lights switch 12 Volt! Manufacturer Bosch! The hazard flasher system uses the
existing flasher relay and is relatively easy to install. Attention: a suitable bulb must be ordered separately. Our article number 14425.
- Suitable for this article
Hazard warning lights switch 6 Volt! Manufacturer Bosch! The hazard flasher system uses the
existing flasher relay and is relatively easy to install. Attention: a suitable bulb must be ordered separately. Our article number 14282.
PDF FILE 
Hazard warning signal switch, universal, 12volt, Manufacturer HELLA The switcher uses the actual
indicator-relais. easy to fit.
Hazard warning light switch, manufacturer Hella. Complete with mounting bracket for retrofitting
The hazard warning light switch is operated via the original flasher relay. Suitable light bulb: 50096 for 12 V. 14271 for 6 V.
Water hose screen wiping water, PVC clear. Inside diameter: 3mm, outside diameter: 5mm. Operating
g pressure maximum 7.5 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 4mm, outside diameter: 6mm. Operating
g pressure maximum 6,0 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 5mm, outside diameter: 7mm. Operating
pressure maximaum 7.0 bar. By meters. Custom cut, return not possible!
White wall rings, 4 fittings. Suitable for Citroen 2CV. Note: The white wall rings can be mounted
only in combination with our rims chrome rings 16815!
Tool 1677-T, for the nuts (6x9mm) the rocker arm and at the gearbox (Citroen 2CV). Clutch housing
(6x9mm) Citroen DS. Attention: The screws are extremely tight. Therefore, first hit the screw head with a hammer (setting impact) to loosen the screw in the thread!
Winter tire 135R15MS. Manufacturer Michelin. Suitable for Citroen 2CV. Also very well as
all-terrain tires for Citroen Mehari.
Winter tire mounts on a new rim, 135/15. Manufacturer Michelin. We use only our own
series-identical rims and no reproduction rims! Suitable for Citroen 2CV.
Wiper blade eleastic, per piece. Suitable for Citroen Dyane + ACDY, AMI6, Mehari, HY. Renault R4
4, Rodeo. Peugeot 403 + 404. 280mm lengthens. Original manufacturer Valeo! For 8mm of wide wiper arms.
Wiper blade - windscreen wiper. Length: 32cm. Material: stainless steel (not polished). For 6,0
6,5mm wide wiper arms with straight connection. Universal suitable. E.g. Citroen DS, AMI, CX, GS. Renault 5,6,12,15,16,17,18. Alpine A110 + 310. Peugeot 204,304,504 and many many other classics.
Wiper blade - windscreen wiper. Length: 37,5cm. Material: stainless steel (not polished). For 5mm
wide wiper arms with straight connection. Universal suitable. E.g. Citroen DS, AMI, CX, GS. Renault 5,6,12,15,16,17,18. Alpine A110 + 310. Peugeot 204,304,504 and many many other classics.
Wiper blade - windscreen wiper. Length: 37.5cm. Material: stainless steel (not polished). For 8>9mm
wide wiper arms with hook - J connection (the wiper arm is bent 180° at the end). Universal suitable. E.g. Citroen DS, AMI, CX, GS. Renault 5,6,12,15,16,17,18. Alpine A110 + 310. Peugeot 204,304,504 and many many other classics.
Gear rack ring in the axle tube (steering gear). Suitable for Citroen 2CV. Reproduction. First
oversize. Outside diameter: about 34,2mm. Inside diameter: 27,5mm.
Gear rack ring in the axle tube (steering gear). Suitable for Citroen 2CV. Reproduction. Standard
dimension. Outside diameter: about 34,00mm. Inside diameter: 27,50mm.
Gear rack ring in the axle tube (steering gear). Suitable for Citroen 2CV. Reproduction. Second
oversize. Outside diameter: about 34,3mm. Inside diameter: about 27,5mm.
Gear rack ring in axle tube 2CV. Reproduction. Made in European Union. Outside diameter 34,05mm
inside diameter 27,50mm.
Gear rack ring in axle tube 2CV. Reproduction. Made in European Union. Outside diameter 34,10mm
inside diameter 27,50mm.
Gear rack ring in axle tube 2CV. Reproduction. Made in European Union. Outside diameter 34,15mm
inside diameter 27,50mm.
Gear rack ring in axle tube 2CV. Reproduction. Made in European Union. Outside diameter 34,25mm
inside diameter 27,50mm.
Gear rack steering unit, 19 teeth. Suitable for Citroen 2CV, starting from year of construction
1955. This gear rack is only Installed by vehicles, which have an steering worm with 7 teeth. Or. No.: A4424b
Steering rack, up to Orga no. 2276. Suitable for Citroen 2CV (steering pinion with 7 teeth). 24
teeth, total length: 365mm. Replica
1739 Articles | Page 34 of 35
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
