2CV, Rear end panel repair sheet metal for Citroen 2CV. It is only the outer skin of the rear end
panel, with the cutouts for the tail lamps. Made in Europe.
panel, with the cutouts for the tail lamps. Made in Europe.
cost starting from 59 Euro.
m. Caution! Increased shipping cost starting from 59 EURO.
Overall length about 2250mm. Made in France
Suitable for Citroen 2CV6 RHD (right hand drive). Made in Europe.
Suitable for Citroen 2CV6. Made in Europe.
for Citroen 2CV6. Made in Europe.
The body was built completely from new parts. The quality of the body is good, however small remachining is necessary. So some spotwelds must be regrind and the transition to the windshield frame should be tinned. The raw sheet metals (before the processing and shaping) are galvanized. New: Attached to the car body, there are some pictures attesting the correct fit since the body has been mounted on a trial basis with original sheet metal components. Made in Europe.
completely from new parts. The quality of the body is good, however small remachining is necessary. So some spotwelds must be regrind and the transition to the windshield frame should be tinned. The raw sheet metals (before the processing and shaping) are galvanized. New: Attached to the car body, there are some pictures attesting the correct fit since the body has been mounted on a trial basis with original sheet metal components. Made in Europe.
Inclusive wall + connection sheet metal. Suitable for Citroen 2CV all years of construction. Very good reproduction, like original. Electrolytically galvanized. Made in Europe.
construction. Take better our own 15459 reproduction!
flanges, drain holes and reinforcement. Electrolytically galvanized. Made in Europe.
e compartment sheet metal under spare wheel). Suitable for Citroen 2CV all years of construction. Good reproduction. Electrolytically galvanizes.
Cross profile. Diameter 32-34mm. (suitable by DS for item 37227 + 35146)
reproduction from the European Union.
Citroen, no reproduction.
compartment lid and leads the lock fastener! Or.Nr. AZ844123. Made in Europe.
seal has been made especially for us. The "rubber flag" is diagonally, therefore there is a better sealing. Consisting of: 3 seals, cut to length and mitred cut. Width of the rubbers: approx. 29mm (like original).
in place. Made in Germany.
sound-deadening material. The trim must be glued in place. Made in Germany.
metal. The emblem is self adhesive. Measurements: 35x240mm
emblem is self adhesive. Measurements: 35x175mm
about 55mm, height of ca.21mm.
about 85mm, height of ca.25mm
about 85mm, height of ca.25mm
the rear end panel. Suitable for Citroen 2CV. Made in Europe.
the rear end panel. Suitable for Citroen 2CV. Made in Europe.
Franzose. The signature 16836 consists of: 1x "2" + 1x "CV". The emblems are fastened with 4x M3 nuts (our article number 20166).
by Franzose. The signature is about 180mm long, and 65mm highly. The emblems are fastened with 2x M3 nuts (our article number 20166).
Also fitting for other Citroen!
are cheaper replicas from Asia that break very quickly. !! Please order the retaining clip 16391 for the locking cylinder separately or reuse the old one!
until 1990. Suitable to the coverings 18362.