ignition for Citroën 2CV 2CValt

Ignition 123UNI is designed for all STANDARD 2CV, Dyane, AMI engines that were ever produced. The

appropriate advance-curve can be selected with a 16 position rotary-switch, behind an opening in the front of the housing. The unit will work on 6 Volt and on 12 Volt systems. The '123\UNI' is designed to work on '2CV' 9 hp, 375cc, A53, M4, A79/0, M28, A79/1 and M28/1 engines in conjunction with the stock black coil. (6 Volt type for 6 Volt battery, and 12 Volt type for 12 Volt battery) The dwell is automatically adjusted. Upon installation, the user has to check his engine plate ( "A", "AZ", "AM", "AYA", "AM2", "AYA2", "AK2", "A06/635", "A06/642", "AM2A" or "A06/664" ) and look in the manual which setting of the rotary-switch is appropriate. There also is a special setting for M28/1-engines running on LPG or on Ethanol, like 'E85' as used in Sweden. ( 'E85' contains 85 percent ethanol, and 15 percent standard fuel )

Condenser for Citroen 2CV + AMI 6 with 6-volt electrical system. Please note: The holder must be

bent into the correct position. We apologize, but other 6-volt condensers are no longer available. An alternative is to convert to a 6-volt electronic ignition system (our item number 14328) or push the car.

Ignition cable set, installed until 11/1979, for Citroen 2CV. OEM quality! The best cables for 2CV

Made in Spain. This cable has a very low ohmic resistance. Suitable for our spark plug 14394. Basic information about interference suppression: Up to the year of construction 1979, the ignition cables had a low resistance. The same applied to the spark plug. Suppression chokes were installed for the suppression. Today, this can be done immediately by combining high-resistance spark plugs with low-resistance ignition cables.

Spark plug wrench (adjustable in length), for 20,8mm spark plugs. This key is perfect for the

Citroen DS. It can be used with the normal electrode extension. Fitting for 3/8 inch ratchet (medium size). Fits of course also on all other spark plugs, for 21mm tools. Manufacturer: HAZET. Adjustable length from: 137,5mm to 157,5mm and 195,5mm. With spark plug holding rubber.

Spark Indicator. This non-contact spark tester will test for the presence of power in spark plugs

coils and distributors. Simply place the grooved end over the spark plug wire with the engine running and the high intensy bulb will flash indicating spark. Note: Depending upon screen of the ignition cables, it can be possible, that you see the flashing by daylight, very bad!