turn signal and indoor lighting for Citroën 2CV 2CValt

Indicator (reversing lamp) completely (clear), original Seima 3054. 3055 (no reproduction, with

test symbol "E"). Metal base + metal support! The glass has 68,5mm diameter! Suitable for Citroen 2CV (in front), AZU + AK (in front), Mehari (in front + rear), DS BREAK (rear), HY (in front). Renault R4, early years of construction.

Indicator completely (Orange), original Seima 3054. 3055 (no reproduction, with test characters)

Metal base + metal support! The glass has 68,5mm diameter! Suitable for Citroen 2CV (in front), AZU + AK (rear), Mehari (in front + rear), AMI6 (rear), DS BREAK (rear), HY (in front + rear). Renault R4, early years of construction.

Side indicator for the rear side at the front fender. Suitable for Citroen 2CV, Dyane, HY, DS. This

indicator is serial installed in many south European countries (Italy, Spain etc.). Outside diameter inclusive chrome ring: 36,0mm.

Turn signal cap yellow (original AXO, with "E" test mark). Suitable for Citroen 2CV in front

Citroen DS BREAK rear. HY in front + rear. AMI6 rear. Renault R4 in front. Wide light collar. Outside diameter 71mm, mounting holes center to center about 55mm, collar heidht measured from the inside: 14,5mm. We could buy some thousand caps. No reproduction (NOS).

Turn signal cap yellow (original SEIMA, with "E" test mark). Suitable for Citroen 2CV in front

Citroen DS BREAK rear. HY in front + rear. Renault R4 in front. Narrow light collar. Outside diameter 68mm. Mounting holes center to center about 58mm. Collar height measured from the inside: 10,0mm. We could buy some thousand caps. No reproduction (NOS).

Turn signal cap clear (original SEIMA, with "E" test mark). Suitable for Citroen 2CV in front

Citroen DS BREAK rear. HY in front + rear. Renault R4 in front. Narrow light collar. Outside diameter 68mm. Mounting holes center to center about 58mm. Collar height measured from the inside: 10,0mm. We could buy some thousand caps. No reproduction (NOS).

Hazard warning lights switch 6 Volt! Manufacturer Bosch! The hazard flasher system uses the

existing flasher relay and is relatively easy to install. Attention: a suitable bulb must be ordered separately. Our article number 14282.