for Citroën Alle
4601 Articles | Page 89 of 93
Water pump (new part) for Citroen HY, Installed starting from year of construction 7/1963. Or
No.5443099V. A old part return is not necessary! Caution: The HY has an open cooling system. It is essential to check if the radiator cap is the right one ! The water pump can evacuate some cooling water through a small opening. New water pumps need approx. 500 km to 1000 km to get at 99,5 % leakproof. It is just normal to see some drops of water on the water pump!
Water pump (new part) HY 9/50 till 9/63, U23. Or.Nr. 456815. Caution: The HY has an open cooling
system. It is essential to check if the radiator cap is the right one ! The water pump can evacuate some cooling water through a small opening. New water pumps need approx. 500 km to 1000 km to get at 99,5 % leakproof. It is just normal to see some drops of water on the water pump!
Seal, for the water pump, down at the engine block. Suitable for Citroen HY. Diameter: 40mm. Or
No. HY235-30. Made in Germany.
Water pump for Citroen DS/ID 19 to year of construction 1964. New part! Caution: The DS19 has an
open cooling system. It is essential to check if the radiator cap is the right one ! The water pump can evacuate some cooling water through a small opening. New water pumps need approx. 500 km to 1000 km to get at 99,5 % leakproof. It is just normal to see some drops of water on the water pump!
Water pump completely in the exchange. Suitable for Citroen 11CV, starting from year of
construction 09/1950. Plus 250 Euro Old part deposit! Or. No. 456649
Water pump completely in the exchange. Suitable for Citroen 11CV, to year of construction 09/1950
The water pump was completely revised and optimized. Like that the new pump impellers with 8 shovels are mounted instead of 6 shovels. Additionally the axle with 2 shaft seals is sealed. The pump must be only easily lubricated. Too much lubricating grease destroys the shaft seals! Plus 250 Euro Old part deposit! Or. No. 451643
Water pump repair set completely, suitable for Citroen DS, starting from year of construction
07/1972 (thermostat in the case). For the engines DX, DX IE, DY. Consisting of: Label water pump, radiator hose down, water pump seal on the engine side, water pump housing, thermostat, 4x stud bolt + 4x suitable nut.
Water pump repair set completely, suitable for Citroen DS, starting from year of construction 1965
(thermostat in the hose). Exceptional are the engines DX, DX IE, DY. Consisting of: Label water pump, radiator hose down, water pump seal on the engine side, water pump housing, thermostat, 4x stud bolt + 4x suitable nut.
Water pump shaft seal (seal water pump). Suitable for Citroen DS19, to year of construction
09.1960. Outside diameter: 41,5mm. Inside diameter down: 27mm. Inside diameter above: 20mm. Overall height: 13,6mm.
- Suitable for this article
Water pump plate, between engine block + water pump. Amended for mounting a water temperature
sensor (M10, 1/8" NPTF). Suitable for Citroen 11CV Perfo (to year of construction 1950). In the exchange. Plus 75 Euro Old part deposit.
Water pump, suitable for Citroen HY Diesel. Peugeot 505 Diesel, Peugeot J7 Diesel. Possibly the two
small connections must be plugged. Or. No. 120187, 120295, 120291, 120288, 120299. Hose flange diameter: 1x 16mm, 1x 55mm, 1x 42mm.
Water pumps seals (2 fittings). Suitable for Citroen 15CV, Installed starting from year of
construction 09/1947. Or. No. 452673 + 456723
Water pump seal (seal of the water pump to the water pump housing). Suitable for Citroen DS
starting from year of construction 1966. Or. No. 5442973
Water pump seal (seal the water pump housing to the cylinder head). Suitable for Citroen DS
starting from year of construction 1966. Or. No. 1D5411691D
Water pump seal small. Suitable for Citroen HY, starting from year of construction 09/1963. Or. No
HY23188A. Made in Germany.
Water pump seal small. Suitable for Citroen U23 + HY to year of construction 9/1963. Or. No
451631. Made in Germany.
Water pump housing, suitable for Citroen DS, starting from year of construction 07/1972. For the
engines: DX, DX IE, DY. Or. No. 2D5433287T
Water pump housing, suitable for Citroen DS, starting from year of construction 1965. Exceptional
are the engines: DX, DX IE, DY. Or. No. 2D5402227L
- Suitable for this article
Water hose screen wiping water, PVC clear. Inside diameter: 3mm, outside diameter: 5mm. Operating
g pressure maximum 7.5 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 4mm, outside diameter: 6mm. Operating
g pressure maximum 6,0 bar. By meters. Custom cut, return not possible!
Water hose screen wiping water, PVC clear. Inside diameter: 5mm, outside diameter: 7mm. Operating
pressure maximaum 7.0 bar. By meters. Custom cut, return not possible!
Water hose, for the windshield washer system. From the link to the wiper washer nozzles on the left
on the right of (3x5mm). Suitable for Citroen DS. Reproduction from black rubber. It is not a clear PVC hose. 1000mm is sufficient for 1 vehicle. By meters! Customer cut, return not possible!
Water hose, from the washer reservoir to the pump (4x6mm). Suitable for Citroen DS. By meters! It
is not a clear PVC hose. 1000mm are sufficient for 1 vehicle. By meters! Customer cut, return not possible!
Water temperature gauge (water thermometer) in the dashboard. Suitable for Citroen DS. For the
latest dashboard version. New part! Or. No. DX521-215A
Water temperature indicator "temperature emblem" transparency (dashboard). Suitable for Citroen DS
starting from year of construction 1969 (final version). Version: JAEGER
Scale (dashboard) for the water temperature indicator. Suitable for Citroen DS, starting from year
of construction 1969 (final version). Version: JAEGER
Corrugated sheet - side plate on the left completely (consisting of 2 sheet metals 149cm). Suitable
for Citroen HY with normal (short) wheel base. The sheet metals have an offset edge, so that they can be added together.
Side plate with flanges. Flanges length: about 1640mm. Sheet metal length: about 1850mm. Suitable
for Citroen HY. The sheet metal has centrically a pressed recess for the mounting of a reinforcement cross-beam. A dispatch is possible only by shipping company. In the case of delivery outside of the European Union, the sheet metal must be cut through by us!
Side plate on the right with flanges. Suitable for Citroen HY. Flanges length: about 1640mm. Sheet
metal length: about 1850mm. The sheet metal has a pressed recess (joggle) at an end, for the mounting (welding) of a further shet plate (long sheet metal for extended HY `s). The combination of our No. 48303 + 48304 results the long sheet metal for the left side. A dispatch is possible only by shipping company. In the case of delivery outside of the European Union, the sheet metal must be cut by us!
Side plate on the right, with flanges. Flanges length: about 1640mm. Sheet metal length: about
1850mm. Suitable for Citroen HY standard length, for on the right of side. The sheet metal does not have pressed recess for the mounting of a reinforcement cross-beam. A dispatch is possible only by shipping company. In the case of delivery outside of the European Union, the sheet metal must be cut by us!
Corrugated sheet metal - side sheet metal, for the rear extension. This plate gives an extension of
approx. 79 cm. The corrugations run out to the rear. The corrugations are cut at the front, so that it can be visually attached directly to the existing corrugations. Suitable for Citroen HY. Per piece.
4601 Articles | Page 89 of 93
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
