Citroen DS Cabriolet. This strip is attached to the top of the door from the inside. The strip is U-shaped and the door trim is pushed into it from below.
front + 2x rear. Suitable for Citroen DS Pallas. This strip is attached to the top of the door from the inside. The strip is U-shaped and the door trim is pushed into it from below. Originally, this strip was only used for the Pallas models (but practically for all models).
These bumpers clogged original on the inside of the doors. They prevent that rub and rattle of the door lining on the door. These bumpers are missing nearly in every, not original, DS.
These bumpers clogged original on the inside of the doors. They prevent that rub and rattle of the door lining on the door. These bumpers are missing nearly in every, not original, DS.
Outside diameter about 8,6mm. Deep about 17mm.
Per piece. For 2CV, you need 5 clips for 1 door lining in front (low version) and 4 for rear. For 7mm holes.
Renault. Per piece. For 2CV, you need 5 clips for 1 door lining in front (low version) and 4 for rear. For 7mm holes!
stainless steel. Or. No. DS983-87. Made in Germany.
for Citroen DS. Made of stainless steel. Or. No. DS983-87.
left + on the right fitting.
left + on the right fitting.
were often used for gearbox identification!
were often used for engine numbers!
Measurements of 43x70mm. Unfortunately a bad reproduction.
Measurements: 43 x 78mm.
Select your Citroen 
Please select your Peugeot 
Please select your Citroen Renault 
