for Renault Alle

R8 Gordini, bumper in front + rear. Suitable for Renault R8 Gordini. Inclusive bumper overriders

Produced from high-grade steel!

R8, turn signal cap angularly. Suitable for Renault R8.

R8, turn signal cap round. Suitable for Renault R8.

R8, Rear brake shoes. Diameter 228mm. Brake pad width: 32mm. Suitable for Renault R8.

R8, sealing rubber set for the door handles. Suitable for Renault R8.

R8, emblem "8". Suitable for Renault R8. Completely made from metal. Wide one: 38mm. Ammount: 31mm

R8, "Renault" bonnet emblem. Suitable for Renault R8.

R8, tail pipe, suitable for Renault R8, R8 Majar, R8S. Installed starting from year of construction

1962.

• Suitable for this article
• 
  Tailpipe trim chromium-plates. 38mm inside diameter. Universal suitable
  22,71 €

R8, front mask (sheet metal). Suitable for Renault R8 Gordini. Perfect reproduction, like original

KTL coats!

R8, rubber cover in the engine front wall, for the crankshaft hole. Suitable for Renault R8.

R8, Rubber stop (4 item) for the door latch (the rubber is mounted in the corner of the door

latch). Suitable for Renault R8

R8, heater radiator. Suitable for Renault R8 + R10

R8, radiator (new part). Suitable for Renault R8. Diameter connection hose top: 35mm, bottom: 35mm

Radiator mesh: 438 x 290mm.

R8, wheel brake cylinder sealing set rear. Suitable for Renault R8 to year of construction 1970

For brake system Bendix. Piston diameter: 22,2mm.

• Suitable for this article
• 
  Brake cylinder paste. Manufacturer: FÖRCH. 5g brake cylinder paste for
  5,31 €

R8, silencer, suitable for Renault R8 Gordini 1300, R1135. Installed starting from year of

construction 1967.

• Suitable for this article
• 
  Tailpipe trim chromium-plates. 48mm inside diameter. Universal suitable
  17,76 €

R8, coverings (2 x front seat, 1x rear seat). Suitable for Renault R8 Gordini. Material: Vinyl

black.

R8, coverings (2 x front seat, 1x rear seat). Suitable for Renault R8 Major. Material: Vinyl black.

R8/10, exhaust silencer, with long connecting piece. Suitable for Renault R8 + R10, for all engines.

R8/A110, brake power controller. Suitable for Renault R8 + Alpine A110. Comparison number Bendix

141.019

R8/A110, support for tail lamp (2 pieces). Suitable for Renault R8 + Alpine A110.

• Suitable for this article
• 
  R8/A110, taillight cap chromium-plate, suitable on the left or on the right
  89,16 €
• 
  R8/A110, rubber for taillight cap. Suitable for Renault R8 + Alpine A110
  7,54 €

R8/A110, rubber for taillight cap. Suitable for Renault R8 + Alpine A110

R8/A110, taillight cap chromium-plate, suitable on the left or on the right. For Renault Renault 8

Alpine A110.

• Suitable for this article
• 
  R8/A110, rubber for taillight cap. Suitable for Renault R8 + Alpine A110
  7,54 €
• 
  R8/A110, support for tail lamp (2 pieces). Suitable for Renault R8 + Alpine
  116,92 €

R8/A110, taillight cap. Suitable for Renault R8 + Alpine A110. Left or on the right suitable. The

edge of the taillight cap is red.

R8/Alpine 110, collar steering gears, particularly for adjustable tie rods. (our No. 83149)

Suitable for Renault R8, R10 + Alpine A110.

• Suitable for this article
• 
  R8/Alpine 110, tie rod, per piece. The tie rods are specialy produced and
  61,33 €

R8/Alpine 110, tie rod, per piece. The tie rods are specialy produced and adjustable, from 285 to

325mm overall length. Suitable for Renault R8 + Alpine A110. Please compare the dimensions! The tie rods are on the left + on the right identically constructed.

• Suitable for this article
• 
  R8/Alpine 110, collar steering gears, particularly for adjustable tie rods
  9,82 €

R8/Floride S/Caravelle, piston + liner (4 item). Suitable for Renault R8, Floride + Caravelle. Year

of construction 1962 to 1967. Engine: Engine 689 01/02. Engine capacity: 956cc. Bore: 65,0mm. Piston pin: 18 x 57mm. Piston rings: 2,0 + 2.0 + 3,5mm. Outside diameter down: 75,48mm. Outside diameter above: 84,75mm. Height totally: 135,0mm.

• Suitable for this article
• 
  piston ring presenting pliers for diameter 40-100.
  22,71 €
• 
  Piston ring compressor, 60 to 90mm clamping range. Hobby version (not for daily
  16,76 €

R8/R10, drive shaft. 20 teeth + 10 teeth, length: 545mm. With nut. Suitable for Reanult R8 + R10.

R8/R10, brake pads. Brake system: Bendix. Suitable for Renault R8, R10, Alpine A110. Wide one

95mm. Amount: 40,5mm. Heavy one: 10,2mm. Or. No. 0996038000

R8/R10, brake pads front. Brake system: Bendix. Suitable for Caravelle, R8, R10, Alpine A110. Wide

one: 95mm. Amount: 40,5mm. Heavy one: 10,2mm. The corners lower are chamfered. Or. No. 0996031700.

R8/R10, brake hose rear. Suitable for Renault R8 + R10. Length: 262mm. Thread: 1x female thread 3/8

8 x 24UNF. 1x male thread 3/8 x 24UNF. Made in Europe.

R8/R10, seal underneath the windshield. Seal to the luggage compartment lid. Suitable for Renault

R8 + R10. Length about 1200mm

R8/R10, sealing profile for the front mask. Suitable for Renault R8 + R10. Length about: 120cm

R8/R10, window channel seal outside (4 pieces). Suitable for Renault R8 + R10.

• Suitable for this article
• 
  R8/R10, clip for the window pit seal. Suitable for Renault R8 + R10
  1,59 €

R8/R10, door window seal for the fixed window in the rear doors (for both sides, 1 set). Suitable

for Renault R8 + R10.

R8/R10, rubber bush for the anti roll bar. Suitable for Renault R8 + R10. Inside diameter: 18mm

Outside diameter: 40mm. Overall height: 25mm.

R8/R10, rubber mat (2 item) for the interior fenders, black. Suitable for Renault R8, R8 Gordini +

R10.

R8/R10, rubber mat in the rear, black. Suitable for Renault R8, R8 Gordini + R10.

R8/R10, rubber mat in front, black. Suitable for Renault R8, R8 Gordini + R10.

R8/R10, clip for the window pit seal. Suitable for Renault R8 + R10

• Suitable for this article
• 
  R8/R10, window channel seal outside (4 pieces). Suitable for Renault R8 + R10.
  84,19 €

R8/R10, luggage compartment seal (by meters). Suitable for Renault R8 + R10. You need about 3

meters! Height: about 31mm. Setting up depth: 13mm.

R8/R10, crankshaft bearing (complete set). Suitable for Renault R8 + R10. Dimension: 0,5 oversize

(2x 25,5mm + 3x 20,3mm).

R8/R10, crankshaft bearing (complete set). Suitable for Renault R8 + R10. Dimension: 0,75 oversize

(2x 25,5mm + 3x 20,3mm).

R8/R10, crankshaft bearing (complete set). Suitable for Renault R8 + R10. Dimension: Standard

dimension. (2x 25,5mm + 3x 20,3mm).

R8/R10, engine gasket set completely, inclusive cylinder head gasket + shaft seals. Suitable for

Renault R8, R8S, R10. Engine: 689-01/03 (956cc). 688-02/06/09 (1108cc).

R8/R10, engine suspension Renault R8 + R10.

R8/R10, bonnet: Rubber buffer for the bonnet. Suitable for Renault R8 + R10.

R8/R10, box sill repair sheet metal on the left, Renault R8, R10, Major. Made in Europe.

R8/R10, box sill repair sheet metal on the right, Renault R8, R10, major. Made in Europe.

R8/R10, tie rod eye (tie rod securement). Suitable for Renault R8 + R10. Thread: M12x1. Made in

Italy

• Suitable for this article
• 
  Nut M12x1
  0,79 €

R8/R10, shock absorber rear (2 fittings). Suitable for Renault R8 Gordini + R10 Gordini. Length

compressed: 250mm. Length extended: 385mm.